-
Date submitted2024-04-16
-
Date accepted2024-06-03
-
Date published2024-07-04
Quantitative determination of sulfur forms in bottom sediments for rapid assessment of the industrial facilities impact on aquatic ecosystems
- Authors:
- Ivan P. Sverchkov
- Vladimir G. Povarov
The article describes an X-ray fluorescence method for quantitative analysis of sulfate and total sulfur in bottom sediments of watercourses and reservoirs located in the area of industrial enterprises impact. The quantitative determination of sulfur forms was carried out by analyzing the characteristic curves SKα1,2 and SKβ1,3, as well as the satellite line SKβ′ on X-ray emission spectra measured by an X-ray fluorescence spectrometer with wavelength dispersion. The study shows that these characteristic curves allow not only to determine the predominant form of sulfur, but also to separately conduct quantitative analyses of sulfates and total sulfur after fitting peaks and to separately analyze overlapping spectral lines. The results of quantitative analysis of the chemical state of sulfur by the proposed X-ray fluorescence method were compared with the results of inductively coupled plasma atomic emission spectroscopy and elemental analysis, as well as certified standard samples of soils and sediments. The results are in good agreement with each other.
-
Date submitted2024-03-07
-
Date accepted2024-06-14
-
Date published2024-07-04
Anomaly detection in wastewater treatment process for cyber resilience risks evaluation
Timely detection and prevention of violations in the technological process of wastewater treatment caused by threats of different nature is a highly relevant research problem. Modern systems are equipped with a large number of technological sensors. Data from these sensors can be used to detect anomalies in the technological process. Their timely detection, prediction and processing ensures the continuity and fault tolerance of the technological process. The aim of the research is to improve the accuracy of detection of such anomalies. We propose a methodology for the identification and subsequent assessment of cyber resilience risks of the wastewater treatment process, which includes the distinctive procedure of training dataset generation and the anomaly detection based on deep learning methods. The availability of training datasets is a necessary condition for the efficient application of the proposed technology. A distinctive feature of the anomaly detection approach is a new method of processing input sensor data, which allows the use of computationally efficient analytical models with high accuracy of anomaly detection, and outperforms the efficiency of previously published methods.
-
Date submitted2022-05-20
-
Date accepted2023-06-20
-
Date published2024-02-29
Increasing the quality of zeolite-bearing rocks from Eastern Transbaikalia by applying directed energy
This paper presents the use of accelerated electrons to treat zeolite-bearing rocks from Eastern Transbaikalia to increase the efficiency of separating zeolites from rock-forming minerals via electromagnetic separation. The effectiveness of the liberation of zeolite minerals using accelerated electrons was analyzed. The results of dry electromagnetic separation of zeolite-bearing rocks are presented. The dependence of the extraction of iron-bearing minerals from zeolite-bearing rocks by electromagnetic separation on the magnetic field intensity for different particle sizes has been established. The main methods of zeolite-bearing rock enrichment and ore preparation were determined. A technological scheme for processing zeolite-bearing rocks, based on the use of accelerated electron treatment at the ore preparation stage, is presented, significantly improving the zeolite production quality.
-
Date submitted2020-06-15
-
Date accepted2020-06-15
-
Date published2020-06-30
Multi-terminal dc grid overall control with modular multilevel converters
This paper presents a control philosophy for multiterminal DC grids, which are embedded in the main AC grid. DC transmission lines maintain higher power flow at longer distances compared with AC lines. The voltage losses are also much lower. DC power transmission is good option for Russian north. Arctic seashore regions of Russia don't have well developed electrical infrastructure therefore power line lengths are significant there. Considering above it is possible to use DC grids for supply mining enterprises in Arctic regions (offshore drilling platforms for example). Three different control layers are presented in an hierarchical way: local, primary and secondary. This whole control strategy is verified in a scaled three-nodes DC grid. In one of these nodes, a modular multilevel converter (MMC) is implemented (five sub-modules per arm). A novel model-based optimization method to control AC and circulating currents is discussed. In the remaining nodes, three-level voltage source converters (VSC) are installed. For their local controllers, a new variant for classical PI controllers are used, which allow to adapt the values of the PI parameters with respect to the measured variables. Concerning the primary control, droop control technique has been chosen. Regarding secondary level, a new power flow technique is suggested. Unbalance conditions are also verified in order to show the robustness of the whole control strategy.
-
Date submitted2019-01-16
-
Date accepted2019-03-07
-
Date published2019-06-25
Sintered sorbent utilization for H2S removal from industrial flue gas in the process of smelter slag granulation
- Authors:
- A. B. Lebedev
- V. A. Utkov
- A. A. Khalifa
Authors suggest removing hydrogen sulfide from the hot industrial gas at temperatures 200-300 °C and its subsequent interaction with Fe 2 O 3 . For this purpose the following sorbents have been proposed: a mixture of iron oxide and fly ash; iron oxide and pumice; different samples of red mud (bauxite treatment residues containing iron oxide). To prevent dusting and loss of absorbing capacity, the sorbents were shaped into porous granules with other metallic oxides. Materials utilized in the study were obtained the following way: mixing of Fe 2 O 3 with fly ash; sintering of the mixture with red mud. The blend contains aluminum oxide and silica, which can act as matrix shapers, alkali oxides and fluxing agents that reduce the temperature during metal sintering. After the samples had been saturated with sulfur, they were positioned in a venting reservoir, where under the temperature 600-700 °C desorption to the initial state occurred by means of passing an air flow through the sorbent layer. In the process of this operation, sulfur dioxide was released and reactive metal oxides re-emerged. Desorption also generated a small amount of elemental sulfur and sulfuric acid. Absorbing capacity was assessed at higher temperatures, efficiency of H 2 S removal reached 95-99.9 %. Proposed technology of air cleaning is recommended to use in metallurgic processes with elevated atmospheric pollution, e.g. granulation of melted blast-furnace slag.
-
Date submitted2018-05-07
-
Date accepted2018-07-06
-
Date published2018-10-24
Hydraulic transportation of thickened tailings of iron ore processing at Kachkanarsky GOK based on results of laboratory and pilot tests of hydrotransport system
- Authors:
- V. I. Aleksandrov
- M. A. Vasileva
The object of study is the system of hydrotransport of iron ore processing tailings at JSC «EVRAZ Kachkanarsky GOK». The aim of the work was to determine the parameters of the hydraulic transport of tailings of the iron ore enrichment at weight concentrations of the solid phase from 30 to 70 % and to develop recommendations for the industrial operation of hydraulic transport systems of highly concentrated slurries of the Tailing Facilities of the Kachkanarsky GOK. Laboratory studies of the parameters of hydrotransport of thickened tail pulps were carried out with the development of a calculation method; pilot tests of the hydrotransport system under the conditions of the Tailing Facilities of the Kachkanarsky GOK. It has been established that using polyurethane coatings on the inner surface of the slurry lines significantly (1.75 times) decrease the specific pressure loss on the hydrotransport of thickened fluids. This allows to significantly increase the range of transportation for placing tailings in the distant parts of the storage zone. The introduction of research results is in the project of reconstruction and development of the tailing facility of the TF of the Kachkanarsky GOK for the period 2018-2020. It is proposed to use the results of work in the project of reconstruction of the hydraulic transport system at the TF of the Kachkanarsky GOK by switching to the hydraulic transport of slurries thickened to weight concentrations of 35-40 % in the slurry pipes with an internal polyurethane coating, which will ensure energy saving in the hydraulic transport process.
-
Date submitted2016-11-18
-
Date accepted2016-12-28
-
Date published2017-04-14
Frequency electromagnetic sounding with industrial power lines on Karelia-Kola geotraverse
The paper describes theory, method and first experimental results of research on the interaction between electromagnetic waves of extremely low and ultra low frequency (0.1-200 Hz), the Earth crust and ionosphere in the field of two mutually orthogonal industrial power lines, 109 and 120 km long, in the course of FENICS experiment (Fennoscandian Electrical conductivity from Natural and Induction Control Source soundings). The main focus was on the observation results along the line of Karelia-Kola geotraverse over a distance of 700 km from the source. High horizontal homogeneity of geoelectrical lithosphere section has been detected in the eastern part of the Baltic shield at depth range from 10-15 to 50-70 km. Parameters of «regular» lithosphere section have been specified to the depth of 60-70 km. As a result of inverse problem solution for the western part of Karelia and Central Finland, a zone of decreased transverse resistivity has been detected at the depth of 50-60 km, corresponding to the area, detected by seismic methods, where Moho boundary reaches the same depth.
-
Date submitted2015-12-28
-
Date accepted2016-02-08
-
Date published2016-12-23
Bulk density and aggregate stability assays in percolation columns
The restoration technologies in areas degraded by extractive activities require the use of their own mine spoils. Reducing deficiencies in physical properties, organic matter, and nutrients with a contribution of treated sewage sludge is proposed. This experiment was based on a controlled study using columns. The work was done with two mine spoils, both very rich in calcium carbonate. Two sewage sludge doses were undertaken (30,000 and 90,000 kg/ha of sewage sludge) in addition to a different mine spoils used as restoration substrates. The water contribution was provided by a device that simulated short duration rain. The leached water was collected 24 hours after the last application. The experiment saw the bulk density decrease and the aggregate stability increase, thereby improving the structure. The improved soil structure decreases its vulnerability to degradation processes such as erosion and compaction.
-
Date submitted2013-07-13
-
Date accepted2013-09-21
-
Date published2014-03-17
Modern technology of consumption waste management in the mining agglomeration
- Authors:
- M. Sh. Barkan
- A. B. Makhovikov
- E. I. Kabanov
Any industrial agglomeration is a territory, not only with a high concentration of industrial facilities, but also with high population density. This, in turn, is an essential prerequisite to problems associated with the large volume of waste consumption. To solve these problems it is necessary not only to improve the technology for processing different kinds of waste, but also to establish a system by their rapid collection and transport.
-
Date submitted2009-08-03
-
Date accepted2009-10-30
-
Date published2010-02-01
Geotechnical engineering features of the estimation of stability of heavy constructions of designed cement works in Novorossiysk
- Authors:
- Yu. V. Khaliullina
In the paper possibilities of constructing industrial heavy structures near slopes are described. The influence of tectonics, seismicity, a relief, deposit rocks thicknesses, their physical properties of geotechnical engineering feature are analyzed. The law of marls durability change is established. Positions of the most probable surfaces of sliding in cracked monoclonal deposit thickness are shown. The estimation of stability of the loaded slopes is made. Some recommendations for maintenance of structure stability are given.
-
Date submitted2008-11-23
-
Date accepted2009-01-30
-
Date published2009-12-11
The estimate of the utilization’s efficiency of the production waste products, which appeared as a result of the preservation of the environment measures
- Authors:
- E. M. Pronin
Nowadays the problems of the stable growth of mineral and source of raw materials and fuel and energy complex industries are attached great importance to, since it influences the country social-economic condition. In its turn the development of the mining industry requires opening up new lands, which are especially vulnerable to different kinds of anthropogenous and technogenous factors. The changes in the state of economic system have excluded the lowering expenditure by the economy of the production scale. The typical features of a new economy became the progress of free competition and intensive demonopolization. At the same time for the mining industry it is significant that large-scale enterprises should be the foundation of many cities economies of the Russian Federation. For the way out of a system crisis it is necessary to change the strategy – to alter not only the condition of the system, but its management. The formation of the mining complexes permits to use sources of raw materials of the exploited deposits in the proper way, to process waste products of the basic production into the commodity output, to raise the efficiency and cut costs of the preservation of the environment measures from concentration waste products, exhaust solutions, gases, warm water harmful influence on the environment. The practical use of the production waste products of the mining complexes is unprofitable and makes sense only because of its opportunity partially compensating the aggregate investments for the preservation of the environment. The estimate of the utilization s efficiency of the production waste products has made.