Submit an Article
Become a reviewer
Vol 186
Pages:
112-115
Download volume:
RUS

Analysis and synthesis of commercial oil using radioisotope measuring the density

Authors:
I. N. Voityuk
About authors
  • Student Saint Petersburg State Mining Institute (Technical University)
Date submitted:
2009-08-16
Date accepted:
2009-10-15
Date published:
2010-02-01

Abstract

This article deals with a system of commercial accounting of oil transported using radioisotope measuring the density, i.e. measurement-wise number of borehole fluid. In this paper we developed a connection diagram for measuring the density of radioisotope in the main pipeline and verification tools for the measurement system.

Keywords:
turbine flowmeter radioisotope measurement of density means of verification automatic firmware
Go to volume 186

References

  1. Акимов В.Ф. Измерение расхода газонасыщенной нефти. М.: Недра, 1978. 250 с.
  2. Амирханов Р.Х. Результаты испытания и эксплуатации блочных автоматизированных установок по замеру количества товарной нефти «Рубин-1» и «Рубин-2» / Р.Х.Амирханов, А.Х.Нурутдинов. Автоматизация и телемеханизация нефтяной промышленности. 1978. № 3. С.210-215.
  3. Кремлевский П.П. Измерение расхода многофазных потоков Л.: Машиностроение, 1982. 155 с.
  4. Любчик М.А. Силовые электромагниты аппаратов и устройств автоматики постоянного тока (расчеты и элементы проектирования). М: Энергия, 1968. 75 с.

Similar articles

Research of the probability of sudden salt rock outbursts on the basis of measuring of their volume shrinkage
2010 Yu. G. Sirenko, A. V. Brovko, A. A. Sankovskii
Geomechanical substantiation of parameters of the fastening of railway tunnels in the conditions of the North Caucasus
2010 N. A. Belyakov
Complex geological engineering and geoenvironmental monitoring as a basis for creation of strategy of Saint Petersburg architectural and historical monuments conservation
2010 A. V. Shidlovskaya
Relationship between wear resistance of cutting bit body of mining tool and distribution of hardness along the cutting bit
2010 M. P. Talerov
Experimental determination of vibration jaw crusher perfomance and characteristic of the crusher two-motor drive in no-load and nominal mode of operation
2010 S. Yu. Tyagushev, O. B. Shonin
Advance of the metallurgical limestone shaft kilning process control system
2010 N. I. Koteleva