Submit an Article
Become a reviewer
Vol 186
Pages:
34-37
Download volume:
RUS
Article
Geology

The influence of change in geotechnical engineering and geoenvironmental conditions during the process of building and operation of constructions of projected Alekseevsky cement factory on their stability (Mordovia Republic)

Authors:
K. V. Pankratova
About authors
  • student Saint Petersburg State Mining Institute (Technical University)
Date submitted:
2009-08-05
Date accepted:
2009-10-26
Date published:
2010-04-22

Abstract

The influence of change engineering-geological and geoenvironmental conditions on stability of cement factory are considered in this paper. Influence of additional humidifying, rise in temperature in the basis of constructions and activization of microbic activity is considered. The specificity of physicomechanical properties of silica rock and upper Jurassic clay is considered. Results of experimental researches of increase in microbic mass in soils at watering and heating are resulted. The estimation influences of temperature on deformation ability soils is given.

Область исследования:
Geology
Keywords:
cement factory water-bearing soils long-lived stability compressibility. strain bacterial mass bearing capacity
Funding:

None

Go to volume 186

References

  1. Engineering geology of the USSR. Vol.2. Platform regions of the European part of the USSR // Edited E.S.Komarov. Moscow: Nedra, 1991. 270 р.
  2. Korolev V.A. General regularities of physical and mechanical properties change of clay soils under the influence of positive temperature // Change of the geological environment under the influence of the person. Moscow: Nauka, 1982. P.55-60.
  3. Campanella R.G. Influence of temperature variations of soil behaviour // Soil and Found. Div., ASCE, 1968. P. 12-23.

Similar articles

Scheelites of Gavrilovskoe deposit (first find)
2010 A. E. Melnik
Definition of dependent cadastral value estimation indicators of urban land sections (on the example of Kostomuksha)
2010 O. Yu. Lepikhina
Calculation of material streams of the pirometallurgical cycle of processing of copper sulphidic raw materials
2010 N. V. Danilova
Increase of efficiency performance of complexes open-cut equipment
2010 A. A. Faul
Analysis and synthesis of commercial oil using radioisotope measuring the density
2010 I. N. Voityuk
The estimation features of vulnerability and desintegration оf subway construction materials in Saint Petersburg
2010 P. V. Kotyukov