-
Date submitted2016-09-06
-
Date accepted2016-11-13
-
Date published2017-02-22
Justified selection of a seam degassing technology to ensure safety of intensive coal mining
- Authors:
- S. V. Slastunov
- E. P. Yutyaev
The paper contains main aspects of methodological approach to objective analytic assessment of maximum permissible output of the mine faces from the viewpoint of gas factor. Analytic forecast is centered around the assessment of methane inflow into the face area from all possible sources, based on fundamental physical laws, modern tools of mathematical modeling and in-situ tests of main properties and state parameters of the gas-bearing coal formation. Objective and reliable estimation of permissible outputs is a starting point for justified selection of a seam degassing technology, that has to be based on time factor and predicted value of gas recovery from a coal seam to a degassing well. Recommendations have been formulated on the selection of degassing technology for the coal seam «Boldyrevsky» of the Kirov mine, based on the use of cutting-edge technological schemes (hydraulic fracture, carried out from development workings, etc.), successfully implemented on the mentioned site.
-
Date submitted2015-08-17
-
Date accepted2015-10-12
-
Date published2016-04-22
Isolation of promising areas to drill for unconventional hydrocarbons petrikovskih sediments Davydovskogo deposit Pripyat Trough
- Authors:
- E.I. Shevelev
Pripyat Trough is the only oil basin in the territory of the Republic of Belarus. Mining is carried out within the basin for 50 years. During this time, the proportion of active stocks decreased significantly, while the share of hard-to-inventories increased. Therefore, due to the depletion of traditional reserves, urgent problem arises in the study and production of unconventional hydrocarbon traps. To this type of traps are Petrikov deposits Davydov field. These deposits have low permeability and capacitive properties, but at the same time in a number of wells in the test sediment in Colon yielded commercial oil inflows. Some of the well in a certain period of development led oil from Petrikov deposits. In similar deposits Rechitsa field yielded commercial oil inflows in drilling horizontal wells with hydraulic fracturing. Until recently, the reservoir Petrikov deposits was listed among the off-balance sheet reserves after drilling – reserves transferred to the balance of C1. Therefore, the input to the development of stranded there is a need to identify the most promising area for drilling horizontal wells, followed by hydraulic fracturing. To perform this work was carried out pointwise interpretation of GIS for all wells Davydov field, the results of which built the geological and petrophysical model of the deposit. Also, the analysis of core samples, the results of drilling. Produced dismemberment Petrikov deposits on two subhorizon on the results of the interpretation of GIS and well logs. The outcome of the work performed is a recommended site for drilling.
-
Date submitted2014-11-01
-
Date accepted2015-01-18
-
Date published2015-10-26
On the design features of underground multiple gassy coal seam mining
- Authors:
- O. I. Kazanin
The analysis of the industry regulatory requirements and the world design experience of underground multiple coal seam mining is provided. The main problems of intensive longwall mining of multiple flat gassy coal seams as well as methods for determination of high rock pressure zone parameters and seams interaction are considered. The examples of a number of mines in the Kuzbass and Pechora coal basins show that the design of multiple seam mining and the choice of longwall panel parameters were often made without taking into consideration influence of surrounded seams that leads to essential complication of conditions for mining operations and decreases the technical and economic indicators of mining. The existing industry regulations do not allow considering complex influence of factors in multiple coal seams mining fully. On the basis of field, laboratory, and numeric research results it is noted that recommendations for pillar positioning in contiguous seams ensuring efficiency and safety of multiple seam longwall mining can significantly differ in case of liability of coal seams to spontaneous combustion, high natural gas content, influence of multiple seam mining onto daily surface, and difficult conditions of entries maintenance. The importance of having information on the stress-strain condition of the rock mass at a design stage and its changes in the process of multiple seam mining is shown. The need for industry regulations updating for the purpose of a more detailed definition of a form, size and a location of high rock pressure zones as well as stress parameters in these zones is noted. A set of recommendations for effective and safe multiple seam mining is developed.
-
Date submitted2009-10-14
-
Date accepted2009-12-03
-
Date published2010-09-22
Some geomechanical aspects in the development of calculation methods of rock pressure in permanent mine workings
- Authors:
- A. M. Kozel
The paper deals with the particular features of the stress-strain state and mechanical condition of the rocks surrounding the permanent mine workings; they should be taken into account in the development and updating of standards and calculation methods to ensure the stability of these workings.
-
Date submitted2009-10-06
-
Date accepted2009-12-24
-
Date published2010-09-22
Geologo-geomechanical developments of structures of deep vertical shafts at coal mines in Donbass
- Authors:
- V. V. Levit
- S. V. Borshchevskii
The lithologo-geomechanical trend of conditions for strengthening the vertical shafts of collieries which coordinates and unites the lithologo-geomechanical and mining factors into a system has been developed.
-
Date submitted2009-07-12
-
Date accepted2009-09-16
-
Date published2010-04-22
Numerical assessment of stress-strain field in vicinity of large open pit mine taking into account geomechanical, geological and mining factors
The results of modeling of rock mass stress state in the vicinity of large open pit mine using finite-elements method are represented. The model allows to take into account the influence of large-scale fractures. The initiation of boundary conditions is based on the results of determination of stress parameters in situ. The locations of risk areas near the slope are defined.
-
Date submitted2009-07-04
-
Date accepted2009-09-10
-
Date published2010-04-22
Provision of safe coal mining with due account оf cleanup works at adjacent seams
- Authors:
- M. A. Ilyashov
During planning of mining works with coal series it is important to take into consideration mining conditions of each mine layer, to determine presence of natural and technogenic abnormal areas at its place and to appreciate their potential level of influence on the increase of rock pressure manifestations in the development and productive workings. In comparable conditions the most negative manifestations of rock pressure can be observed in roadways of neighboring low layer, when they are disposed in range of mutual action of abnormal areas of natural and technogenic origins.
-
Date submitted2009-07-12
-
Date accepted2009-09-08
-
Date published2010-04-22
Account and movement of reserves in the information system of Silvinit co.
- Authors:
- A. V. Kataev
- S. N. Kutovoi
- E. M. Efimov
- M. V. Gilev
At ore mines of the Silvinit Co. for accounting and movement of reserves are developed and used special tools, using GIS within the information system. Their use allows to automate accounting and monitoring of status and movement of stocks, including the formation of the reporting tables.