Submit an Article
Become a reviewer
Vol 198
Pages:
122-125
Download volume:
RUS
Article

Provision of geodynamic safety in mining the Barentsburg coal deposit

Authors:
M. V. Shvankin1
M. A. Rozenbaum2
Yu. Ya. Minin3
V. P. Stetsenko4
A. V. Bondarev5
About authors
  • 1 — Ph.D. leading research assistant National Mineral Resources University (Mining University)
  • 2 — Ph.D., Dr.Sci. laboratory head National Mineral Resources University (Mining University)
  • 3 — Ph.D. senior research assistant National Mineral Resources University (Mining University)
  • 4 — Ph.D. chief expert «Saint Petersburg Hyproshakht-XT» Ltd
  • 5 — chief engineer of Mine №1- 5, Barentsburg State Trust «Arcticugol»
Date submitted:
2011-10-05
Date accepted:
2011-12-08
Date published:
2012-11-19

Abstract

The minable seam «Verkhny» within the Barentsburg coal deposit is geodynamically hazardous, its geodynamic phenomena manifest itself in the form of proper rock bursts, shocks in the marginal zones and dynamic faults of ground. Due to rockburst-hazardous situation the application of the areal relief of rock mass with transition to technological variants of mining with leaving the extended rib pillars at the boundary with the mined-out space, with their cutting by drivage of additional working is applied. Consideration is given to the recommended variants of pillar leaving with the data of their assignment and applicability to geological-and-mining conditions of mine field sections. Description is given to the calculation of pillar sizes and parameters used for their calculations. Some examples are given of pillar leaving at different sections of mine field with geometrical parameters as well as the information is given on the seam extraction with prospecting routes (paths) with leaving the support rib and barrier pillars. The leaving of safety support and barrier pillars with substantiation of their sizes is recommended as the method for providing the safe condition of mining the «Verkhny» coal seam

Область исследования:
(Archived) Innovation in designing of mining plants
Keywords:
coal seam rockburst hazard mining technology safety rib pillars assignment of pillars variants of pillar leaving methods for geomechanical calculation of pillars pillar sizes in seam mining practice efficiency of pillar leaving
Go to volume 198

References

  1. Methodological manual for choice of geomechani-cal parameters of coal seam mining technology with short faces / VNIMI. Saint Petersburg. 2003. 56 p.
  2. RF Patent N 2296859. Method of mining the flat and inclined rockburst-hazardous seams / D.V.Yakovlev, M.A.Rozenbaum et al. No 2005125297/03; Заявлено 10.08.2005; Publ. 10.04.2007. Bul. N 10. Priority 10.08.2005.
  3. RF Patent N 2224890. Method of mining the flat and inclined rockburst-hazardous seams / M.V.Shvankin, A.V.Kuznetsov, Yu.Ya.Minin. N 2002124540/03; Publ. 27.02.2004. Bul. N 6. Priority 17.09.2002.
  4. Directions for prevention of geodynamic phenom-ena in mining the coal seams of the Barentsburg deposit / VNIMI. Saint Petersburg, 2009. 56 p.

Similar articles

To the question of maintenance of permanent workings ventilation-waste floor in techtonic stressed zones «Big Gorst» of «Taimyr» mine
2012 V. A. Zvezdkin, V. N. Karelin, T. S. Mushtekenov
Safety problems of mining operations in high-stress hard rock massif
2012 A. A. Kozyrev, V. I. Panin, Yu. V. Fedotova
Mechanism of infuence on the powered roof support of rocks under different schemes of its failure above the mined-out space
2012 S. G. Baranov, M. A. Rozenbaum
New ore and coal extracting and processing technologies at arcelormittal temirtau JSC mining plants
2012 F. Pannir, A. M. Gazaliev
Science-based procedural guidelines for coalmine methane drainage under conditions of higly gas-bearing seam intensive mining
2012 V. B. Artemev, A. D. Ruban, V. N. Zakharov, V. S. Zaburdyaev
Scientific provision of disigning mineral deposit mining
2012 A. V. Kotenkov, I. G. Kharisov