Operation of vertical mine shafts in complex mining and geological conditions is associated with a number of features. One of them is a radial displacement of the concrete shaft lining, caused by the influence of mining pressure on the stress-strain state of the mine workings. A rigid reinforcing system with shaft buntons fixed in the concrete lining thus experiences elastoplastic deformations, their value increases with time. It results in deviation of conductors from design parameters, weakening of bolt connections, worsening of dynamic properties of geotechnical system “vehicle – reinforcing”, increase of wear rate of reinforcing system elements, increase of risks for creating an emergency situation. The article offers a comprehensive assessment of displacements of characteristic points of the bunton system based on approximate engineering relations, numerical modeling of the deformation process of the bunton system and laser measurements of the convergence of the inner surface of the concrete shaft lining. The method was tested on the example of the reinforcing system of the skip-cage shaft of the potash mine. Displacement of the characteristic points of the reinforcing system is determined by the value of radial displacements of the surface of the concrete shaft lining. Evaluation of the radial displacements was made using monitoring measurements and profiling data. The results obtained make it possible to justify the need and timing of repair works. It is shown that the deterioration of the reinforcing system at different levels occurs at different rates, defined, among other things, by mechanical properties of the rock mass layers located at a given depth.

The low quality of voltage in the centers of supply of loads of mining sites during normal operation of the distribution network required regime measures to improve it ...

The distribution network of potash mines is characterized by a large length and energy intensity. Therefore, the voltage value in remote parts of the network often reaches unacceptable values according to GOST ...

Protection of longitudinal compensation units of CPC from overvoltages at short-circuits in the network of 6 kV can be implemented by means of thyristor arrester, included in parallel to capacitors of CPC ...

The loads of mining machine drives are characterised by significant irregularity and, as correlation analysis of the operating modes of extraction and tunnelling combines demonstrates, contain periodic components with a frequency range of 0.5–20 Hz. In extensive mine networks, cutter-loader electric motors often cannot stably sustain a load equal to their rated power. ...

In electric drive systems, capacitive braking of squirrel-cage induction motors is employed either autonomously or in combination with other operating modes. The braking torque on the motor shaft, depending on the circuit configuration and initial conditions, arises either from machine self-excitation, capacitor discharge, or a combination of both effects simultaneously. ...