Submit an Article
Become a reviewer
Vol 155 No 2
Pages:
127-130
Download volume:
RUS
Research article
Mining electromechanics

Experimental determination of the contact thermal resistance of steel pipes with rolled and L-shaped wound aluminum alloy fins

Authors:
K. B. Semenido
About authors
  • Russian State University of Oil and Gas
Date submitted:
2002-07-22
Date accepted:
2002-08-23
Date published:
2003-12-30

Abstract

Reduction of heat transfer coefficient of air-cooled sections can reach 50 % due to imperfection of mechanical contact of steel tube and ribbed shell. For the purpose of wider introduction of L-shaped coiled tubes into industry, measurements of their contact thermal resistance (CTR) by temperature jump and heat flux in the contact zone, as well as comparison with tubes with rolled fins under otherwise equal conditions in the temperature range of 30-300°С were carried out. The research showed that in the temperature range of 150-300°С the wound tubes have considerably higher CTR than the rolled tubes. After a series of experiments, the aluminum strip of L-shaped ribbing was annealed, but heating the sample to 200°С did not lead to annealing of aluminum ribs.

Семенидо К.Б. Экспериментальное определение контактного термического сопротивления стальных труб с накатным и L -образным навитым оребрением алюминиевым сплавом // Записки Горного института. 2003. Т. 155 № 2. С. 127-130.
Semenido K.B. Experimental determination of the contact thermal resistance of steel pipes with rolled and L-shaped wound aluminum alloy fins // Journal of Mining Institute. 2003. Vol. 155 № 2. p. 127-130.
Go to volume 155

Similar articles

Implementation of information technologies in accounting and management processes at coal mining enterprises with the open-pit mining method
2003 A. V. Kovalevskii
System of quantitative analysis, assessment and rationing of combined technogenic impacts on water bodies
2003 T. A. Petrova
Study of the Guinean bauxite leaching process
2003 O. E. Morozova
Study of hydrogen sulfide corrosion in plugging materials
2003 V. V. Salyaev
Theoretical justification of the effective type of turbo-motor for the drive of hydraulic motors
2003 A. L. Bukin
Environmentally friendly technologies for disintegrating clay sands in the development of gold and platinum deposits
2003 A. V. Karepanov