Submit an Article
Become a reviewer
Vol 170 Iss. 1
Pages:
80-83
Download volume:
RUS
Article

Determination of 3D area of existence of spur involute meshing with a given overlapping coefficient

Authors:
A. S. Fokin
About authors
  • Research assistant G.V. Plekhanov Saint Petersburg State Mining Institute
Date submitted:
2006-07-19
Date accepted:
2006-09-12
Date published:
2007-03-02

Abstract

It is shown that the use of combined displacement in gear design makes it possible to considerably expand the area of existence of meshing with non-standard radial clearance. The influence of parameters of the rack-and-pinion producing contour on the area of existence of the meshing is presented, the technology of realization of the tantan-gential displacement in gear cutting is described.

Область исследования:
(Archived) Mining electromechanics
Go to volume 170

Similar articles

Engineering-geological and geo-ecological assessment of the stability of the rich iron ores of the Yakovlevsky mine (KMA)
2007 P. V. Kotyukov
To calculation of parameters of drilling and anchoring installation
2007 V. I. Medvedkov, S. S. Dranov, V. P. Shebin
Strategy of electric energy quality assurance in power supply systems of gas pumping enterprises
2007 Yu. A. Sychev
Management of borrowed capital formation (on the example of JSC MNPO Polymetal)
2007 N. M. Ovchinnikova
Mathematical modeling of control subsystem of aluminum electrolyzer with annealed anodes
2007 P. A. Petrov
Determination of optimum degree and economically acceptable limits of iron ore beneficiation and metallization of iron ore pellets
2007 V. A. Fedoseev, A. A. Antipin