Problem of calculation of head losses by Leibenzon formula in mixed friction zone of turbulent mode
About authors
- 1 — Ufa State Petroleum Technical University
- 2 — Ufa State Petroleum Technical University
Abstract
A comparative analysis of the experimental values of the hydraulic resistance coefficient λ in the mixed friction turbulent mode zone (ZMF) with the values calculated by the most common calculation dependencies has been carried out. It is found that if the co-equivalent roughness is determined on the basis of the solution of the inverse problem, then any of these formulas can be used to calculate λ in the ZMF with an error acceptable for engineering calculations. To reduce the error of friction head hτ calculation using Leibenzon's formula, the approximation of Altshul's formula was performed, as a result of which new coefficients β and m for ZMF were calculated and the boundary Reynolds numbers for this zone were specified.
Область исследования:
(Archived) Geotechnical engineering, powerengineering and automation
Funding:
None
Similar articles
Experimental research concerning the influence of external diameter on the behavior of coiled tubing to cyclic bending with internal pressure
2007 Vlad Ulmanu, Dragos Zisopol, Ciprian Trifan
Special conditions of transportation routes construction in undermined areas in Czech Republic
2007 Jaroslav Broul, Jiří Husárik
The research of vertical displacements of the rock mass inside and in environment of the Kletno Bear Cave
2007 Joanna Andrzejewska