Improvement of heat treatment regimes of cutters of road-headers for increase of their wear resistance
About authors
- 1 — G.V. Plekhanov Saint Petersburg Mining Institute
- 2 — G.V. Plekhanov Saint Petersburg Mining Institute
- 3 — G.V. Plekhanov Saint Petersburg Mining Institute
- 4 — G.V. Plekhanov Saint Petersburg Mining Institute
Abstract
The method is offered which allows to increase the wear resistance of bit bodies for continuous miners by means of their additional full hardening. This results in increasing the bit body hardness from 37-42 HRC up to 49-51 HRC, which must bring to increasing in wear resistance approximately of 25 %. The suggestion has been tested with a batch of bits spec. RKS-2 (РКС-2) in the mines of Vorkuta and have demonstrated an increasing in wear resistance compared with that of the bits which had not been exposed to an additional hardening.
Область исследования:
(Archived) Diagnostics and control of technical systems and their elements. New technologie
Funding:
None
Similar articles
Bench studies of a manual perforator with a piston-bowl impact system
2008 A. Ya. Burak, D. A. Jungmeister, A. Yu. Vasiliev, Yu. V. Sudienkov
Relevance of application of centralized protection with inverse dependent time-current characteristic of RXIDG type for networks with resistive neutral groundi
2008 M. A. Bychin
Calculation of parameters of pipe-water transportation of hydraulic mixtures with high concentrations of solid phase
2008 V. I. Aleksandrov, V. P. Pirozhenko, P. B. Gurkin