Submit an Article
Become a reviewer
Vol 181
Pages:
153-155
Download volume:

Automatic system of stabilization of sulphur production from waste gases of autogenous generators

Authors:
K. M. Botviniev
About authors
  • Norilsk State Industrial Institute
Date submitted:
2008-08-30
Date accepted:
2008-10-04
Date published:
2009-02-01

Abstract

Vanyukov's process of extraction is an autogenous method for sulfide concentrates of nonferrous metals. Melting is accomplished in a specially designed furnace and is accompanied by generating sulfur dioxide bearing off-gases. Different sulfur removal methods are used to reduce sulfur dioxide emissions into the atmosphere, of which the Claus process is the most significant process of gas desulfurizing. The efficiency of a typical Claus process can achieve as much as 80% of sulfur recovery. However, the existing control system enables achievement of not more than 60- 70% efficiency due to lack of an adequate process model. The paper presents an automated control system which is based on a fuzzy model of sulfur dioxide recovery.

Go to volume 181

References

  1. Черепанов К.А. Производство металлов за Полярным кругом: Технологическое пособие / К.А.Черепанов, Г.И.Черныш. Норильск: Библиотека «Норильского никеля», 2007. 296 с.
  2. Леоненков А.В. Нечеткое моделирование в среде MATLAB и fuzzyTECH СПб: БХВ-Петербург, 2005. 736 с.: ил.

Similar articles

Research of regularities of salt rocks strength change from conditions of occurrence
2009 A. Yu. Lytkina
Organization of mining works at preparation of new horizons at watered open pits
2009 I. I. Dudanov, V. S. Avraamov, D. N. Ligotsky, G. A. Kholodnyakov
Application of self-propelled equipment on cleaning works at hard ore mining
2009 N. V. Peretyatko
Analysis of the system of state regulation of subsoil use
2009 A. S. Krasnaya
Justification of the parameters of the chamber and pillar system of development during the mining of declivity coal seams
2009 V. A. Shuklin
Optimization of operation modes of gas pumping units in the system of compressor station compression
2009 V. V. Kichatov