Submit an Article
Become a reviewer
Vol 214
Pages:
51
Download volume:
RUS

Method of diagnostics of diesel engines in timing of the operating cycle

Authors:
A. S. Afanasev1
A. A. Tretyakova2
About authors
  • 1 — National Mineral Resources University (Mining University)
  • 2 — Military Academy of Logistics
Date submitted:
2014-10-01
Date accepted:
2014-12-11
Date published:
2015-04-01

Abstract

To maintain diesel engines in working condition there have been developed methods of diagnosing local crankshaft rotation developed by each cylinder. Inoperative cylinder has an angular velocity of rotation that does not respond the technical conditions. The measuring and computing complex consisting of personal computers, diagnostic complex «MotoDoc III», software and a set of sensors was developed for measuring. The results of the measurement and analysis of time parameters are displayed on the monitor screen. The software facilitates the recording of a signal, its processing and storage, as well as the ability to display the results. The method of diagnosis involves a number of stages: preparation of a diesel engine and equipment, the holding of general and local diagnosis, diagnosing. Thus, it appears possible to carry out condition monitoring of diesel engines by CIP method.

Go to volume 214

References

  1. Афанасьев А.С. Диагностирование военной автомобильной техники / А.С.Афанасьев, А.Н.Крайнов, Ю.В.Михалев; Военная академия материально-транспортного обеспечения. СПб, 2013. 211 с.
  2. Афанасьев А.С. Методика повышения достоверности и полноты технического диагностирования дизелей / А.С.Афанасьев, А.А.Третьяков, М.А.Марченко // Проблемы управления рисками в техносфере: Научно-аналитический журнал. 2014. № 1. С.56-59.
  3. Патент на полезную модель № 103188. Переходное устройство диагностической установки / А.А.Третьяков. Опубл. 27.03.2011.
  4. Патент на полезную модель № 92470. Приспособление для диагностирования дизеля КамАЗ-740 / А.А.Третьяков. Опубл. 20.03.2010.
  5. Транспортная энергетика: Учеб.пособие / В.Р.Бурячко, Ю.В.Михалев, А.С.Афанасьев; Военная академия мате-риально-транспортного обеспечения. СПб, 2014. 340 с.

Similar articles

Improving the precision of manufacturing power hydraulic cylinders of powered roof supports based on a vibration-damping tooling system
2015 V. V. Maksarov, Yu. Olt
Conservation of municipal solid waste landfills for landfill gas utilization
2015 M. A. Pashkevich, T. A. Petrova
Optimum operating zones selection methods for multispectral overhead power lines remote sensing devices
2015 V. A. Shpenst
Productivity of ore and placer gold deposits of the priamur province
2015 V. A. Stepanov, A. V. Melnikov
Modeling of geomechanical processes in ore mass using physically nonlinear model
2015 A. G. Protosenya
Nickel electrolyte purification from ferrum (III) and copper (II) impurities by extraction using a mixture of oleic acid and triethanolamine
2015 L. A. Voropanova, N. T. Kisiev