It is shown that the use of force resonance leads to the effect of “shaking” the formation, followed by breaking up the film oil and involving it in the further filtration process. For the first time in oilfield geophysics, the concept of passive noise-metering method is justified for monitoring oil and gas deposit development by measuring the quality factor of the contours in the point areas of formation development channels in interwell zones. It is established that determining the depth of modulation for the reactive substitution parameter of the linear FDC chain is crucial not only for determining the parametric excitation in FDC attenuation systems, but also without attenuation in the metrological support for the analysis of petrophysical properties of rock samples from the wells. It is shown that based on the method of complex amplitudes (for formation pressure current, differential flow rates, impedance), different families of resonance curves can be plotted: displacement amplitudes (for differential flow rates on the piezocapacity of the studied formation section), velocities (amplitudes of formation pressure current) and accelerations (amplitudes of differential flow rates on the linear piezoinductivity of the FDC section). The use of predicted permeability and porosity properties of the reservoir with its continuous regulation leads to increased accuracy of isolation in each subsequent sub-cycle of new segment formation in the FDC trajectories, which contributes to a more complete development of productive hydrocarbon deposits and increases the reliability of prediction for development indicators.
The article discusses the problems associated with metrological support of equipment for geophysical research, issues of ensuring the uniformity of well measurements, the creation of Russian standards for calibrating well equipment when determining the porosity coefficients and oil, gas, water saturation, determining the parameters of defects during well cementing and technical condition of casing strings and the water-oil-gas flow. The problems of creating full-fledged methods for measuring the parameters of oil and gas fields with conventional and hard-to-recover reserves have been investigated. The key directions of development of the Russian metrological support of geophysical well measurements were determined. The tasks that need to be solved to create metrological support for geophysical well logging as an industry that meet international standards are indicated. The expediency of creating a Russian Geophysical Center for Metrology and Certification, the need to develop a new and update the existing regulatory framework, which will allow Russian geophysics to reach the level of world leaders in the field of geophysical research, are substantiated.
