Determination of 3D area of existence of spur involute meshing with a given overlapping coefficient
Authors:
About authors
- Research assistant G.V. Plekhanov Saint Petersburg State Mining Institute
Abstract
It is shown that the use of combined displacement in gear design makes it possible to considerably expand the area of existence of meshing with non-standard radial clearance. The influence of parameters of the rack-and-pinion producing contour on the area of existence of the meshing is presented, the technology of realization of the tantan-gential displacement in gear cutting is described.
Область исследования:
(Archived) Mining electromechanics
Funding:
None
Similar articles
Dissection and correlation of red-colored strata on the basis of X-ray diffractometric analysis of clay fraction minerals
2007 A. G. Bogatyreva
Economic evaluation of variants of complex development of oil resources of territories of Timan-Pechora oil and gas province
2007 E. I. Sapozhnikova
Monitoring of soil and vegetation cover for reclamation of the ecological disaster zones of JSC Severonickel
2007 D. S. Korelskiy