Submit an Article
Become a reviewer
Vol 174
Pages:
132-134
Download volume:
RUS

Investigation of dynamic loads of frame structures of peat machines

Authors:
A. N. Pavlov
About authors
  • Tver State Technical University
Date submitted:
2007-07-26
Date accepted:
2007-09-07
Date published:
2008-03-17

Abstract

The movement of peat machines is complicated by the presence of unevenness in the form of bumps and stumps, high moisture content of the deposit in some areas and, finally, deformability of the peat deposit. All this significantly worsens the passability of peat machines in comparison with machines moving on flat hard ground. The purpose of the tests is to select the most rational frame variant in terms of its durability, minimum weight and manufacturability of construction.

Go to volume 174

References

  1. Волков В.С. Исследование напряжений и основы расчета элементов рамы гусеничных торфяных машин (на примере торфостилочной машины ЭСМ-8А): Автореф. канд. техн. наук. Калинин, 1968.
  2. Караваева Н.М. Автоматическое управление и динамика энергомеханических структур торфяных машин. М.: Недра, 1975.
  3. Фомин К.В. Элементы статической динамики торфяных машин: Учеб. пособие. Тверь, 2001.

Similar articles

Geometrization of deposits with commercial hydrocarbon content in volcanogenic formations of triassic age based on the complex of geological and geophysical data
2008 E. V. Efimova
Causes of oil deposits zonality formation in carbonate reservoirs on the example of oil deposits in the south-east of the Republic of Tatarstan
2008 A. N. Kolchugin
Determination of hafnium in zirconium compounds using flame atomic absorption spectrometry (FAAS)
2008 Agata Jakóbik – Kolon, Marek Smolik, Ewa Miodek
Investigation of the possibilities of water-gas influence on the reservoir using pump-ejector units
2008 D. I. Popov
Slope stabilisation method on S7 «Zakopianka» road case
2008 Michal Godzinski, Paluch Lukasz
Large scale investments in Russia’s infrastructure and natural resources sector
2008 Thomas Schumann