Investigation of dynamic loads of frame structures of peat machines
Authors:
About authors
- Tver State Technical University
Abstract
The movement of peat machines is complicated by the presence of unevenness in the form of bumps and stumps, high moisture content of the deposit in some areas and, finally, deformability of the peat deposit. All this significantly worsens the passability of peat machines in comparison with machines moving on flat hard ground. The purpose of the tests is to select the most rational frame variant in terms of its durability, minimum weight and manufacturability of construction.
References
- Волков В.С. Исследование напряжений и основы расчета элементов рамы гусеничных торфяных машин (на примере торфостилочной машины ЭСМ-8А): Автореф. канд. техн. наук. Калинин, 1968.
- Караваева Н.М. Автоматическое управление и динамика энергомеханических структур торфяных машин. М.: Недра, 1975.
- Фомин К.В. Элементы статической динамики торфяных машин: Учеб. пособие. Тверь, 2001.
Similar articles
Solution of problems of water flooding of high-viscosity oil deposits in carbonate reservoirs
2008 V. V. Mukhametshin
Experimental researches for the reduction of the noxes during the burning of pit coal from Jiu Valley – Romania
2008 Ciolea Daniela Ionela
Geometrization of deposits with commercial hydrocarbon content in volcanogenic formations of triassic age based on the complex of geological and geophysical data
2008 E. V. Efimova
Investigation of development system variants with ore and host rock collapse by computer modeling
2008 A. M. Gildeev