Cutting technology with point attack picks on roadheaders and its challenges
Authors:
About authors
- Mining University Leoben
Abstract
The presentation devoted to the cutting technology with point attack picks; it demonstrates typical cutting units and cutting machines. Hereby the criteria for a succesful setup of such a mining system are explained. Also the presentation keeps the focus on the assessment and check of cuttability. It describes measurement methods to identify important rock parameters and to evaluate the tool’s perfomance on special test equipment. The assessment of a complete cutting system’s performance is shown by means of on site measurements.
Область исследования:
(Archived) Geotechnical engineering, powerengineering and automation
Funding:
None
Similar articles
Method of determination of friction coefficient at rolling of billets on crimping and thick plate mills
2009 M. V. Tsymbalyuk
Organization of mining works at preparation of new horizons at watered open pits
2009 I. I. Dudanov, V. S. Avraamov, D. N. Ligotsky, G. A. Kholodnyakov