The improvement of selective extraction of thick potash seams mined with room and pillar mining method
About authors
- 1 — канд. техн. наук Associate professor Saint Petersburg State Mining Institute (Technical University)
- 2 — Student Saint Petersburg State Mining Institute (Technical University)
- 3 — Ph.D. assistant lecture Saint Petersburg State Mining Institute (Technical University)
Abstract
Technological scheme of selective extraction of a complex thick potash seam on the basis of cutting machine «Bucyrus Model 25 M0» is proposed. Stable pillars’ width and room dimensions are calculated. Economical effect is also presented.
Область исследования:
Mining
Funding:
None
References
- Kovalsky E.R. Problems of increase of extraction ratio // Commercial development of mineral resources of the North: problems and solutions / Branch of SPMI «Vorcut. mining institute». Vorkuta, 2006. V.2. P.93-98.
- Regulations and methodical documents for mining works at potash deposit «Starobinskoe» / NTP «Gornyak». Soligorsk - Minsk, 1995/214 p.
- Olovianniy A.G. Certain problems of rock mechanics / FGUE «Intersectoral scientific center» VNIM. Saint Petersburg, 2003. 234 р.
Similar articles
Experimental determination of vibration jaw crusher perfomance and characteristic of the crusher two-motor drive in no-load and nominal mode of operation
2010 S. Yu. Tyagushev, O. B. Shonin
The integrated reloading point at the combined auto-railway transportation
2010 M. M. Yakubovskii, G. A. Kholodniakov
The ontogenetic analysis of the vein quartz of some deposits of Southern Urals mountains
2010 E. L. Kotova
The phenomenon of spontaneous termination of the discharge current and the establishment of fully-managed key elements of the plasma
2010 A. S. Mustafaev, S. A. Vysotskii, M. A. Cherkasova, M. A. Mamelkina