Submit an Article
Become a reviewer
Vol 197
Pages:
138
Download volume:
RUS

Legitimacies of flushing method formation by mechanically in the conditions of long-term frozen grounds

Authors:
S. A. Tolstunov1
A. V. Montikov2
About authors
  • 1 — National Mineral Resources University (University of Mines)
  • 2 — National Mineral Resources University (University of Mines)
Date submitted:
2011-09-07
Date accepted:
2011-11-04
Date published:
2012-03-01

Abstract

On the basis of the experimental data received at erection mass of a file by throwing car with the bottom emission of breed, in the conditions of negative temperatures laws  of distribution and a trajectory of flight of pieces of breed of the various sizes are established.

Go to volume 197

References

  1. Байконуров О.А. Технология разработки рудных месторождений с твердеющей закладкой. Алма-Ата, 1978.
  2. Левченко А.К., Петренко Е.В., Сурков А.Г. Экономическая целесообразность оставления породы в шахте. М., 1968.
  3. Разработка мощных крутопадающих угольных пластов Кузбасса с закладкой. М., 1951.
  4. Толстунов С.А., Монтиков А.В. Перспективы применения гибкой технологии отработки многолетнемерзлых пород // Записки Горного института. СПб, 1995. Т.142(1).
  5. Толстунов С.А., Модестов Ю.А., Монтиков А.В. Гибкая технология отработки пластов многолетнемерзлых пород // Горный журнал. 1990. № 7.

Similar articles

Commercialization of results of scientific researches and development as factor of innovative development of economy
2012 V. A. Knysh
Main problems of new generation open pit mines design
2012 S. P. Reshetnyak
Development and technological background of diamond bits
2012 Yu. E. Budyukov, V. I. Spirin, V. P. Onishchin
Biotic and abiotic components in underground space: genesis and effect on condition and properties of sandy soils
2012 R. E. Dashko, A. V. Shidlovskaya
Assessment of groundwater limitations in the context of Saint-Petersburg territory development
2012 V. V. Antonov
Formation of cracks in breeds of the face оf the chink under the influence of chisel cutters
2012 L. K. Gorshkov, V. G. Gorelikov