Submit an Article
Become a reviewer
Vol 209
Pages:
71
Download volume:
RUS

Modeling and control of dynamical properties of the technological systems

Authors:
V. V. Maksarov1
P. V. Leonidov2
About authors
  • 1 — National Mineral Resources University (Mining University)
  • 2 — National Mineral Resources University (Mining University)
Date submitted:
2013-09-10
Date accepted:
2013-11-15
Date published:
2014-07-18

Abstract

The article describes the static and dynamic characteristics necessary for the assessment of the properties of the technological system. It is shown, that the basic static and dynamic characteristics are the stiffness of the bearing systems of the machine, the geometric precision and accuracy of the sizes and the form of the processed product. In the paper a method of constructing dynamic models of small dimensionality, on the basis of which the modeling and management of technological systems of mechanical processing. The dynamic characteristics of the techno-logical system of defined areas of sustainability of the process of cutting.

Go to volume 209

References

  1. Кудинов В.А. Динамика станков. М., 1967. 359 с.
  2. Максаров В.В. Теория и практика моделирования и управления в области прогнозирования динамических свойств технологических систем / В.В.Максаров, Ю.Ольт // Металлообработка. 2012. № 2. С.7-13.
  3. Соколовский А.П. Вибрации при работе на металлорежущих станках / В кн.: Исследование колебаний при резании металлов. М., 1958. С.3-23.
  4. Maksarov V.V., Olt J., Madissoo M. Dynamic Stabi-lization of Technological Systems for Processing Edge Cut-ting Through Local Metstability // USB Proceedings. IEEE International Symposium on Assembly and Manufacturing, 25th-27th May 2012 Tampere Hall Tampere, Finland.

Similar articles

To the question of the reсycling of cars
2014 Yu. N. Katsuba, S. V. Egorov
Chemical-thermal treatment of steel in an environment of low-melting solutions
2014 A. V. Sivenkov
Modern technologies for processing and briquetting of metal shavings in automated factories
2014 E. G. Zlotnikov, V. V. Maksarov
Technology of surface processing and design requirements
2014 T. P. Gorshkova, E. N. Kostyleva
To the guestion of the vibration load on the slide mast in the heavy duty drilling rigs
2014 Yu. A. Petrov, A. I. Keksin
Methodics of calculation of required amount of cars in reduced interval delivery times
2014 T. A. Menukhova