Technological capabilities of inverter power source for gas metal arc welding
About authors
- 1 — Ph.D. associate professor National Mineral Resources University (Mining University)
- 2 — Ph.D. associate professor National Mineral Resources University (Mining University)
Abstract
The article is about an inverter power source used in the industry (a current up to 500 A, a duty cycle up to 60%, an inverter frequency not below 20 kHz) for the gas metal arc welding. There technical and technological advantages over the thyristor rectifier are discussed.
Область исследования:
(Archived) Manufacturing machinery and equipment
Similar articles
Modeling simulation of structure in a heat-affected zone of welded joint from low-alloyed steels
2014 E. I. Pryakhin, D. M. Sharapova
Mathematical modeling of movement of the bottom device during its transporting by flexible traction element
2014 G. A. Kolton, I. A. Korolev, I. P. Timofeev
Evaluation of gas parameters in explosive type displacement pumps
2014 A. B. Nezametdinov, M. G. Menzhulin, S. V. Khokhlov, P. V. Shishkin
About resistant steel 110G13L in different abrasive media
2014 V. I. Bolobov, A. P. Batalov, V. S. Bochkov, S. A. Chupin