Physical aspects of matelcutting in the local influence
Authors:
About authors
- Ph.D. associate professor National Mineral Resources University (Mining University)
Abstract
The article describes the physical aspects of the machining blanks in the preliminary local thermal impact on the material are examined, they allow to operate the process of shaving segmentation at the mashing on the lathes.
Область исследования:
(Archived) Manufacturing machinery and equipment
Funding:
None
References
- Weitz V.L., Maksarov V.V. Localization and instability of plastic deformation during the chip formation in metal cutting // Mechanical Engineering and Automation. N.13. Saint Petersburg, 1999. P. 39-43.
- Weitz V.L., Maksarov V.V. Physical principles modeling of chip formation during cutting // Mechanical Engineering and Automation. N.13. Saint Petersburg, 1999. P.44-46.
- Weitz V.L., Maksarov V.V., Lonza P.A. Dynamicsand modeling of cutting for machining. Irkutsk, 2000. 189 p.
- Livshits L.S. Metallography for welders. Moscow, 1979. 243 p.
Similar articles
Validation of transport-tractor unit passability by organogenic deposits development
2014 A. V. Telego, A. V. Mikhailov, A. V. Bolshunov
Effect of design parameters of the front-end equipment of the mining shovels load on dynamics
2014 S. Yu. Kuvshinkin
Methodics of calculation of required amount of cars in reduced interval delivery times
2014 T. A. Menukhova
Selection of alloying elements in steels for obtaining images full range of colors on the surface of the products by means of a pulsed laser radigation
2014 O. Y. Ganzulenko, A. P. Petkova