Tangential stresses in hollow shafts in bending
Authors:
Abstract
In many practical proposals there is a need to calculate the tangential stresses in hollow shafts in bending. The ratio of inner diameter to outer diameter in hollow shafts is chosen very differently depending on the purpose of the shaft. In cases where the removal of the central part of the cross-section is intended to control the quality of the material, the inner diameter of the shaft is usually small. The formulas available in the literature for determining the greatest tangential stress in hollow shafts in bending usually do not take into account the effect of the diameter ratio on the magnitude of the tangential stress.
Область исследования:
(Archived) Articles
Keywords:
-
References
- Ivanov N.I. Resistance of Materials. Gostekhizdat, 1942.
- Belyaev N.M. Resistance of Materials. Gostekhizdat, 1951.
- Druzhinin S.I. and Yagn Y.I. Resistance of Materials. Gostekhizdat, 1933.
- Filonenko-Borodach M.M. et al. Resistance of Materials. Gostekhizdat, 1949.