Multiphysical model of heterogenous flow moving along а channel of variable cross-section
- 1 — Saint-Petersburg Mining University
- 2 — Technische Hochschule Georg Agricola
Abstract
The article deals with the problem aimed at solving the fundamental problems of developing effective methods and tools for designing, controlling and managing the stream of fluid flowing in variable-section pipelines intended for the production of pumping equipment, medical devices and used in such areas of industry as mining, chemical, food production, etc. Execution of simulation modelling of flow motion according to the scheme of twisted paddle static mixer allows to estimate the efficiency of mixing by calculating the trajectory and velocities of the suspended particles going through the mixer, and also to estimate the pressure drop on the hydraulic flow resistance. The model examines the mixing of solids dissolved in a liquid at room temperature. To visualize the process of distributing the mixture particles over the cross-section and analyzing the mixing efficiency, the Poincaréplot module of the COMSOL Multiphysics software environment was used. For the first time, a multi-physical stream of heterogeneous flow model has been developed that describes in detail the physical state of the fluid at all points of the considered section at the initial time, takes into account the design parameters of the channel (orientation, dimensions, material, etc.), specifies the laws of variation of the parameters at the boundaries of the calculated section in conditions of the wave change in the internal section of the working chamber-channel of the inductive peristaltic pumping unit under the influence of the energy of the magnetic field.
References
- Зайцев А.В. Моделирование течения вязкой жидкости в трубе / А.В.Зайцев, Ф.В.Пеленко // Научный электронный журнал НИУ ИТМО. Серия: Процессы и аппараты пищевых производств. 2012. № 1. С. 163-168 Режим доступа: http://processes.open-mechanics.com/
- A mathematical model of fluid flow in tight porous media based on fractal assumptions / Y.Jin, X.Li, M.Y.Zhao, X.H.Liu, H.Li // International Journal of Heat and Mass Transfer. 2017. № 108. Р. 1078-1088.
- Afrasiabikia P. Scenarios for improvement of water distribution in Doroodzan irrigation network based on hydraulic simulation / P.Afrasiabikia, A.P.Rizi, M.Javan // Computers and Electronics in Agriculture. 2017. № 135. Р. 312-320.
- Alexandrov V. Turbulent Transport of Solid Phase in Hydrotransport / V.Alexandrov, M.Vasilyeva // Papers presented at the 15th International Freight Pipeline Society Symposium; The Institute of Hydrodynamics AS CR, Academy of Sciences of the Czech Republic. Prague, 2014. P. 3-9.
- Ates S. Hydraulic modelling of control devices in loop equations of water distribution networks // Flow Measurement and Instrumentation. 2017. № 35. Р. 243-260.
- Boundedness and stabilization in a two-dimensional two-species chemotaxis-Navier-Stokes system with competitive kinetics / M.Hirata, S.Kurima, M.Mizukami, T.Yokota // Journal of Differential Equations. 2017. № 263(1). Р. 470-490.
- Bruno O.P. On the quasi-unconditional stability of bdf-adi solvers for the compressible Navier-Stokes equations and related linear problems / O.P.Bruno, M.Cubillos // Siam Journal on Numerical Analysis. 2017. № 55(2). Р. 892-922. DOI: 10.1137/15M1042279.
- Fang F. Mathematical Constraints in Multiscale Subgrid-Scale Modeling of Nonlinear Systems / F.Fang, M.W.Ge // Chinese Physics Letters. 2017. № 34(3), № 030501. DOI: 10.1088/0256-307X/34/3/030501.
- Lai M.C. A short note on Navier-Stokes flows with an incompressible interface and its approximations / M.C.Lai, Y.Seol // Applied Mathematics Letters. 2017. № 65. Р. 1-6. DOI: 10.1016/j.aml.2016.09.016.
- Modeling of Perforated Sill-Controlled Hydraulic Jump / M.Fathi-Moghadam, S.Kiani, P.Asiaban, R.Behrozi-Rad // International Journal of Civil Engineering. 2017. № 15(4А). Р. 689-695.
- Non-linear modelling and stability analysis of the PTGS at pump mode / L.Wang, Q.S.Han, D.Y.Chen, C.Z.Wu, X.Y.Wang // IET Renewable Power Generation. 2017. № 11(6). Р. 827-836.
- Nouri A.Z. Mathematical modeling of concrete pipes reinforced with CNTs conveying fluid for vibration and stability analyses // Computers and Concrete, 2017. № 19(3). Р. 325-331.
- Numerical modelling of a point-absorbing wave energy converter in irregular and extreme waves / W.C.Chen, I.Dolguntseva, A.Savin, Y.L.Zhang, W.Li, E.Svensson, M.Leijon // Applied Ocean Research. 2017. № 63. Р. 90-105. DOI: 10.1016/j.apor.2017.01.004.
- Olsen J.E. VLES turbulence model for an Eulerian-Lagrangian modeling concept for bubble plumes / J.E.Olsen, P.Skjetne, S.T.Johansen // Applied Mathematical Modelling. 2017. № 44. Р. 61-71.
- Ottosson A. A mathematical model of heat and mass transfer in Yankee drying of tissue / A.Ottosson, L.Nilsson, J.Berghel // Drying Technology. 2017. № 35(3). P. 323-334.
- Vasilyeva M. Justification of the Choice Matrix Material of the Magnetoactive Elastomer for Working Camera-Channel Peristaltic Unit // Materials Science Forum. 2016. № 870. P. 13-19.
- Vasilyeva M. Perspectives of Application of 3D Shape Memory Composite Materials for Peristaltic Transportation of Slurries // Key Engineering Materials. 2015. № 685. P. 291-294.