Submit an Article
Become a reviewer
Vol 105
Pages:
3-9
Download volume:
RUS
Article

Some issues of high speed diamond drilling

Authors:
G. A. Blinov
V. I. Vasiliev
Date submitted:
1984-09-30
Date accepted:
1984-11-22
Date published:
1985-11-27

Abstract

The development and widespread introduction of high-speed diamond drilling into the practice of geological exploration for solid minerals requires the study of the nature of the direct interaction of the diamond drill bit with the rock, since it is here that the main factors affecting the efficiency of rock destruction and the performance of the rock-destroying tool should be sought.

Область исследования:
(Archived) Without section
Go to volume 105

References

  1. Andreeva A.A., Blinov G.A. Research of drilling process at ultra-high rotation speeds of diamond microcrowns. - In the book: Methods and technique of exploration. Collection of scientific works / VITR, 1974, No. 90.
  2. Vasiliev V.I., Kaulin V.A., Zorin V.N. The value of rock-destroying tool deepening per revolution is the most important factor in developing the parameters of high-speed drilling mode. - In the book: Development and Improvement of Diamond Drilling Technology in Complex Mining and Geological Conditions: M., PH VPO Soyuzgeotechnika, 1983.
  3. Illarionova T.M., Gorin V.N. Critical speed of diamond crowns rotation taking into account temperature resistance of diamonds when using traditional flushing liquids (water, clay solution). - In the book: Methods and Technique of Exploration. Collection of scientific articles / VITR, 1978, No. 121.
  4. Kragelskiy I.V., Dobychin M.N., Kombalov V.S. Fundamentals of calculations on friction and wear. M., Mashinostroenie, 1977.
  5. Lipatnikov V.P. Investigation of Hydraulic Characteristics of Washing Fluid Flow in the "Rock - Crown" Zone. - In the book: Development and Improvement of Diamond Drilling Technology in Complex Mining and Geological Conditions. M., ed. VPO Soyuzgeotechnika, 1983.

Similar articles

Calculation of the working process of a compressor with a liquid piston for gas-liquid systems
1985 V. G. Vartykyan, N. S. Vulisanov, A. I. Kirsanov, N. I. Slyusarev, O. Yu. Ustyushenkova
Formation of the average value of the mechanical speed of diamond drilling
1985 A. V. Sakharov
Pressure in the foam flow at water penetrations in a borehol
1985 A. M. Yakovlev, A. F. Kryuchkov
Results of field tests of the high-frequency thermo-drilling complex TBS-112 HF while drilling a deep borehole in a low-temperature glacier cover (Vostok Station).
1985 E. A. Zagrivny
Gas-volume express method of carbonativity determination in argillites
1985 I. V. Godun, A. N. Kholodok
Estimation of hydraulic resistances at pneumatic impact drilling with foam
1985 V. Ya. Klimov