Submit an Article
Become a reviewer
Vol 138
Pages:
15-22
Download volume:
RUS
Research article
Without section

Existence area of spur gear meshing with a given overlap coefficient

Authors:
S. L. Ivanov
Date submitted:
1992-09-04
Date accepted:
1992-11-21
Date published:
1993-12-28

Abstract

Widespread use of gear hydraulic machines, and in particular hydraulic pumps, is explained by their high manufacturability and simplicity of design. However, the presence of the pinched volume of the pinion hydraulic machine, due to the realization of the zone of two-pair meshing at the overlap coefficient ε α >I, leads to a decrease in the volumetric efficiency of the hydraulic machine, as well as requires technological and design measures to unload the pinched volume, which ultimately affects the labor intensity of the manufacture of the hydraulic machine, reduces the resource of operation.

Go to volume 138

References

  1. А.с. 1413274 СССР. МКИ F 04 С 2/08. Шестеренная гидромашина внешнего зацепления. И.П. Иванов, С.Л. Иванов (СССР). Опубл. 30.07.88. Бюп. № 28.
  2. А.с. 1613686 СССР. МКИ F 04 С 2/08. Шестеренная гидромашина / И.П. Иванов, С.Л. Иванов, С.Г. Локшинский (СССР). Опубл. 15.12.90. Бюп. № 46.
  3. Иванов И.П., Иванов С.Л. Оптимизация зубчатых зацеплений шестеренных насосов. М., 1987. Деп. в ВНИИТЭМР. 01.04.87. № 162.

Similar articles

Press for production of double-layer fuel coal briquettes
1993 Yu. D. Tarasov, V. V. Denegin, G. V. Sokolova, Yu. S. Fedorov, Yu. N. Marusov, N. K. Ulashchik
Calculation of parameters of wave processes at start-up of multi-drive belt conveyor
1993 M. M. Vetyukov, D. A. Jungmeister, V. A. Avdeev
Statics and kinematics of vehicles with spiral-chain traction device on inclined track
1993 N. P. Boytsov, I. N. Boytsova
Methods of determining the service life of mining equipment
1993 M. D. Kolomiytsov, B. S. Makhovikov
Theoretical studies of parameters of a walking landing gear with a movable float
1993 I. P. Timofeev, N. K. Ulashchik
Automated calculation of optimal cutting modes during machining
1993 Yu. P. Boytsov