Submit an Article
Become a reviewer
Vol 155 Iss. 1
Pages:
50-53
Download volume:
RUS
Article

Goals and objectives of passportization of stockpiles of formed technogenic deposits

Authors:
E. B. Gridina
About authors
  • Postgraduate student G.V. Plekhanov Saint Petersburg State Mining Institute
Date submitted:
2002-06-21
Date accepted:
2002-07-05
Date published:
2003-12-08

Abstract

The article considers one of the most pressing problems of modern mining science - the problem of formation and development of technogenic deposits. It is known that modern technogenic deposits were formed by the method of bulk dumping, taking into account only two requirements: the minimum cost of dumping work and ensuring the stability of the slopes of the dumps. It is proved that the solution of the problem of complex use of technogenic deposits is connected not only with the possibility of increasing their consumption today, but also with the necessity of creating perspective sources of raw materials. In this connection the question of formation of technogenic deposits acquires paramount importance. The passport of the stockpile of rocks - wastes of the open pit of Kostomuksha Mining and Processing Plant is presented. The fourth main technological process of open-cast mining is proposed to be termed not as dumping, but as stockpiling.

Область исследования:
(Archived) Development of mineral deposits
Funding:

None

Go to volume 155

Similar articles

Faculty of Mining and Electrical Engineering. History of formation and current state
2003 A. S. Fokin
Experience in expert evaluation of facing granite
2003 A. Ya. Tutakova
On the issue of integrated assessment of spatial conditions of land use
2003 E. N. Bykova
Comparative analysis of the coal-bearing capacity of the Podmoskovnoye and Kamskoye basins
2003 A. V. Gazizova
Calculation algorithm of layered massif to predict the stress state of the roof and the coal seam in the zone of mining operations
2003 A. P. Gospodarikov, S. V. Vasilev, M. A. Zatsepin
Ways to intensify the grinding process in cylindrical mills with steel grinding media
2003 A. M. Vasilev