Experimental evaluation of wear resistance of spur gears
About authors
- 1 — G.V. Plekhanov Saint Petersburg State Mining Institute
- 2 — G.V. Plekhanov Saint Petersburg State Mining Institute
Abstract
Extensive opportunities to influence the properties of involute gears are available with combined displacement of tooth profiles - a combination of radial and tangential displacements, including the use of cutting tools with a standard initial contour. In particular, by combined displacement, the bending strength and wear resistance of cylindrical gear teeth can be increased by one and a half to two times, which is commensurate with material replacement.
Область исследования:
(Archived) Mining engineering technologies. Diagnostics and control of technical systems and their elements. New technologies
Similar articles
Laboratory bench based on flame and gas detection sensors
2004 M. A. Semenov, I. A. Pavlov, N. P. Kulikov
Dynamic rock destruction machine systems
2004 L. S. Ushakov, Yu. E. Kotylev, V. A. Kravchenko, D. A. Yurev
Rational placement of teeth in the peripheral rings of the drill bit cones
2004 Yu. G. Matveev, A. N. Popov, A. A. Chekhov