Structural and thermal stresses occurring during press-fit mounting process
Authors:
About authors
- University of Science and Technology
Abstract
The paper describes a method of calculating the pressure connection by cooling or heating one of the elements and based on the temperature balance. It is found that in some conditions the mounting stresses may exceed the nominal stresses. A method of calculating these stresses with high accuracy is proposed. The method is substantiated by numerical analysis.
Область исследования:
(Archived) Mining electromechanics
Funding:
None
Similar articles
Computer modeling and determination of rational parameters of non-shooting reinforcement of vertical shafts
2006 A. A. Urmazov
Tamponage materials on the basis of magnesia cement for casing cementing in deposits of water-soluble salts. Determination of relative position of wells
2006 Yu. S. Ugolnikov
Improvement of technology of fastening of near-well zone with the purpose of liquidation of overflows in gas-condensate wells
2006 D. V. Mardashov