Selection and calculation of autogenous and semi-autogenous grinding mills
Authors:
About authors
- Postgraduate student G.V. Plekhanov Saint Petersburg Mining Institute
Abstract
Traditional methods of selection and sizing calculations for autogenous and semi-autogenous grinding mills that can affect the measurement of power input, such as mill drum liner design and power feed preparation, and comments on some modern developments are reviewed.
Область исследования:
Metallurgy
Funding:
None
Similar articles
Reduction of dust load at technological processes of formation of dusty surfaces at quarries by foaming method
2007 Yu. V. Shuvalov, Yu. D. Smirnov
Reduction of dust emission at quarries using phase transitions of moisture
2007 Yu. V. Shuvalov, N. A. Gasparyan
Peculiarities of calculation of bearing capacity of a conveyor with a suspended belt
2007 D. E. Lunev
Dissection and correlation of red-colored strata on the basis of X-ray diffractometric analysis of clay fraction minerals
2007 A. G. Bogatyreva