Submit an Article
Become a reviewer
Vol 181
Pages:
104
Download volume:
RUS
Article

Cutting technology with point attack picks on roadheaders and its challenges

Authors:
Hubert Kargl
About authors
  • Mining University Leoben
Date submitted:
2008-08-21
Date accepted:
2008-10-20
Date published:
2009-03-20

Abstract

The presentation devoted to the cutting technology with point attack picks; it demonstrates typical cutting units and cutting machines. Hereby the criteria for a succesful setup of such a mining system are explained. Also the presentation keeps the focus on the assessment and check of cuttability. It describes measurement methods to identify important rock parameters and to evaluate the tool’s perfomance on special test equipment. The assessment of a complete cutting system’s performance is shown by means of on site measurements.

Область исследования:
(Archived) Geotechnical engineering, powerengineering and automation
Go to volume 181

Similar articles

Research of influence of magnetic field on foaming properties of VKP reagent and flotation of graphite ore of different sites of Taiga deposit
2009 I. R. Masyagutova
Optimization of operation modes of gas pumping units in the system of compressor station compression
2009 V. V. Kichatov
Use of stochastic models for hydrodynamic analysis of water intakes operation
2009 Yu. P. Starodubova
Application of self-propelled equipment on cleaning works at hard ore mining
2009 N. V. Peretyatko
Modeling of movement of cleaning and diagnostics means on a section of oil pipeline
2009 P. K. Kalashnikov, A. M. Kuvichko
Research of regularities of salt rocks strength change from conditions of occurrence
2009 A. Yu. Lytkina