Submit an Article
Become a reviewer
Vol 186
Pages:
34-37
Download volume:
RUS
Article
Geology

The influence of change in geotechnical engineering and geoenvironmental conditions during the process of building and operation of constructions of projected Alekseevsky cement factory on their stability (Mordovia Republic)

Authors:
K. V. Pankratova
About authors
  • student Saint Petersburg State Mining Institute (Technical University)
Date submitted:
2009-08-05
Date accepted:
2009-10-26
Date published:
2010-02-01

Abstract

The influence of change engineering-geological and geoenvironmental conditions on stability of cement factory are considered in this paper. Influence of additional humidifying, rise in temperature in the basis of constructions and activization of microbic activity is considered. The specificity of physicomechanical properties of silica rock and upper Jurassic clay is considered. Results of experimental researches of increase in microbic mass in soils at watering and heating are resulted. The estimation influences of temperature on deformation ability soils is given.

Область исследования:
Geology
Keywords:
cement factory water-bearing soils long-lived stability compressibility. strain bacterial mass bearing capacity
Go to volume 186

References

  1. Engineering geology of the USSR. Vol.2. Platform regions of the European part of the USSR // Edited E.S.Komarov. Moscow: Nedra, 1991. 270 р.
  2. Korolev V.A. General regularities of physical and mechanical properties change of clay soils under the influence of positive temperature // Change of the geological environment under the influence of the person. Moscow: Nauka, 1982. P.55-60.
  3. Campanella R.G. Influence of temperature variations of soil behaviour // Soil and Found. Div., ASCE, 1968. P. 12-23.

Similar articles

Reseach of cutoff grade influence on economic performances of mining
2010 M. D. Morozov
Experimental determination of vibration jaw crusher perfomance and characteristic of the crusher two-motor drive in no-load and nominal mode of operation
2010 S. Yu. Tyagushev, O. B. Shonin
Relationship between wear resistance of cutting bit body of mining tool and distribution of hardness along the cutting bit
2010 M. P. Talerov
The valuation of cost of the mining company in the reorganization
2010 D. M. Dmitrieva, T. V. Ponomarenko
Spacing of lattice in labradorite and interference model of iridescent
2010 A. P. Simakov
Advance of the metallurgical limestone shaft kilning process control system
2010 N. I. Koteleva