Selection of parameters economically advantage reactive power compensation
Authors:
About authors
- engineer Mining and Metallurgical Institute
Abstract
The article content different methods of modeling elements of the electrical network in the presence of harmonics in voltage and current, but also studied and compared. It is shown that when calculating the power network should be considered a surface effect and the effect on the occurrence of eddy currents. When accounting for these factors, the calculation error mode power consumption is significantly reduced.
Область исследования:
(Archived) Economical problems in use of subsurface and development of the mineral resources complex
Funding:
None
References
- Inelec I.L. The graphical solution for power system analysis. USA. 2006. 230 p.
- IEEE. Recommended practice for industrial and commercial power systems analysis. USA. 1997. 118 p.
- Sains S.L. Formulation of the harmonic load flow // IEEE Transaction on Power Systems. 1995. Vol.13. N 1. P.123-135.
- Garcia P., Pereira J., Sandoval C., Vender M., Martins N. Three-phase power flow calculations using the current injection method // IEEE Transaction on Power Systems. 2000. Vol.5. N 1. P. 98-105.
Similar articles
Ultra wide band gpr-method: success and problems
2011 V. B. Boltintsev, V. N. Ilyakhin, K. P. Bezrodnyi
Structure of superimposed haloes of deep-seated polymetallic deposits (based on example of Аltaiski krai)
2011 S. G. Alekseev, S. A. Veshev, N. A. Voroshilov, E. G. Margovich, A. P. Nikitichev, A. S. Dukhanin
Peculiiarities of geodynamic development оf the devonian graben at Spitsbergen archipelago
2011 A. N. Sirotkin, D. V. Nikitin
Technology and management of yakutian kimberlitic tubes underquarry deposits mining at difficlult hydrogeological conditions
2011 Vladimir S. Litvinenko, E. I. Boguslavskii, M. N. Andreev