Acceptable risk assessment of production in mining industry
About authors
- 1 — Ph.D., Dr.Sci. professor National Mineral Resources University (University of Mines)
- 2 — Ph.D., Dr.Sci. professor National Mineral Resources University (University of Mines)
- 3 — Ph.D. National Mineral Resources University (University of Mines)
- 4 — Ph.D., Dr.Sci. associate professor National Mineral Resources University (University of Mines)
Abstract
In article the possible approach to an assessment of production acceptable risk at level of mining branch or the large enterprise is presented (mine, mine), specifics of which production activity is objectively connected with ineradicable today dangers.
Область исследования:
(Archived) Technologies in chemistry, concentration and metallurgy. Safety problems
Funding:
None
References
- Grishin V., Buldakova E., Istomin R., Kovshov S., Sedov A. Usin g analysis of variance in the study of the level of injury a mining // Mining informational and analyticalbulletin. 2012. No 3. P.222-225.
- Методические указания по проведению анализа риска опасных производственных объектов. РД 03-418- 01 (Утверждены постановлением Госгортехнадзора России от 10.07.01 No 30. Введены в действие с 01.09.01 г.) . М., 2001.
- Methodical instructions on carrying out the analysis of risk of dangerous production objects of RD 03-418 -01 (N 30 are approved by the resolution of Gosgortekhnadzor of Russia from 10.07.01. Are installed since 01.09.01).Мoscow, 2001.
Similar articles
Diagnostics of continuous technological process based on fuzzy topological identification
2012 M. Yu. Shestopalov, Yu. A. Korablev
Deep open pit walls design using rock mass stress-strained state
2012 S. P. Reshetnyak, Yu. V. Fedotova, S. N. Savchenko
The classification and quantitative assessment of innovation project risks
2012 Yu. A. Kulik, V. N. Volovich, N. G. Privalov, A. N. Kozlovskii
Formation of cracks in breeds of the face оf the chink under the influence of chisel cutters
2012 L. K. Gorshkov, V. G. Gorelikov