Submit an Article
Become a reviewer
Vol 202
Pages:
278-283
Download volume:
RUS
Article

Microalloying of aluminum as the method оf changing properties of powder oxidation film

Authors:
A. Yu. Baimakov1
S. Yu. Petrovich2
R. A. Seitenov3
V. A. Lipin4
A. L. Shakhmin5
About authors
  • 1 — Ph.D. associate professor Saint Petersburg State Polytechnical University
  • 2 — laboratory chief Saint Petersburg State Polytechnical University
  • 3 — master Saint Petersburg State Polytechnical University
  • 4 — Ph.D., Dr.Sci. professor Saint Petersburg State Polytechnical University
  • 5 — Ph.D. Saint Petersburg State Polytechnical University
Date submitted:
2012-09-09
Date accepted:
2012-11-23
Date published:
2013-04-29

Abstract

The method of x-ray electronic spectroscopy investigated influence of strontium, bismuth and a lead and tin alloy on structure of superficial films of powders of oxide of aluminum. It is established that alloying additives are surface-active substances and concentrate mainly in a blanket, partially being oxidized together with aluminum. Being formed superficial films have impact on consumer properties of aluminum powders.

Область исследования:
(Archived) Without section
Keywords:
aluminum powders alloying superficial films strontium bismuth tin lead
Funding:

None

Go to volume 202

References

  1. Zhilinskiy V.V., Scherbakov V.K., Lokenbah A.K., Abele R.Yu. Outer oxide film phase composition influence on interreacting aluminium powders with water // Development of casting technique, aluminum treatment and generation of silicium: Collected papers. Leningrad, 1985. P.45-49.
  2. Scherbakov V.K., Lokenbah A.K., Murnietse A.H. et al. Physical-chemical properties and reactive capacity of sprayed aluminium powder of increased degree of dispersion // Developing of new manufacturing methods for aluminium factories: Collected papers. Leningrad, 1991. P.94-99.
  3. Scherbakov V.K., Lokenbah A.K., Zaporina N.A.Structure and formation of oxide and metal constituent of sprayed aluminium powder // Development of casting technique, aluminum treatment and generation of silicium and powder: Collected papers. Leningrad, 1992. P.52-57.

Similar articles

Oxidative melting of sulfide melts with the formation of low-siliceous slags
2013 G. V. Konovalov, T. R. Kosovtseva
Investigation of the colored organic compounds behavior in aluminate liquors during electrolysis treatment
2013 Yu. A. Zaitsev, E. V. Tikhonova, E. V. Sizyakova
Control and management e of electric arc ratio in ore-smelting furnace
2013 A. P. Suslov, N. I. Koteleva, Yu. L. Zhukovskii, V. V. Vasilev
Thermodynamic of lanthanum (iii) and samarium (iii) extraction by using stoichiometric concentration solutions of naphtenic acid
2013 D. S. Lutskii, T. E. Litvinova, D. E. Chirkst, V. A. Lutskaya, S. V. Zhukov
Modelling of thickening process in mineral processing
2013 K. A. Zatulovskii, I. N. Beloglazov, A. Yu. Firsov
About possibility of the mass granite crushed stones wastes utilization
2013 A. V. Alikin