Accuracy of the mashining turning process of the workpieces, when cutting tool equipped with removable ceramic inserts
About authors
- 1 — National Mineral Resources University (Mining University)
- 2 — National Mineral Resources University (Mining University)
Abstract
The article considers the issues of improving the quality of the turning process due to the forecasting performance of cutting tools, equipped with removable ceramic inserts, on the basis of the influence of structural parameters of the material on its performance. The received results allow determining the reserve of process accuracy on the lathe.
References
- Исследование работоспособности инструмента, оснащенного сменными пластинами из режущей керамики / В.В.Максаров, Ю.Ольт, Т.Лаатсит, А.Д.Халимоненко // Инструмент и технологии. 2008. № 30-31. С.132-136.
- Максаров В.В. Управление качеством процесса точения инструментом из режущей керамики: Монография / В.В.Максаров, Ю.Ольт, А.Д.Халимоненко. СПб, 2010. 172 с.
- Маргулес А.У. Резание металлов керметами. М., 1980, 160 с.
Similar articles
Analysis of the environmental situation in the place parking lots and parking in Saint-Petersburg
2014 E. G. Tsyplakova
Technology options for improvement mechanical properties of welded joints made of steel 09Г2С
2014 O. F. Khafizova, A. M. Fairushin, D. V. Karetnikov
The parameters defining power efficiency of dump trucks in opencast mine
2014 S. R. Kuznetsov, M. A. Vasileva