Pressure flow fluid organization in the canal cooling of the large motor units
Authors:
About authors
- Ph.D. associate professor Mineral Resources University (Mining University)
Abstract
This article is about the methods to be used for creating pressure flow fluid inside large motor units. Their good and bad sides are marked. One another scheme of the pressure flow of fluid in the canal cooling large motor units is suggested.
Область исследования:
(Archived) Manufacturing machinery and equipment
Funding:
None
References
- Certificate of authorship 81981. A model for investigating hydrodynamic processes inside large motor, s units filled with liquid dielectric / V.A. Denisov, G.V. Vilin, V.S. Kozlova, J.G. Polybojarinov. Was pubished in Interuniversiti 1981. Digest N 13.
- Certificate of authorship 915174. Liquid-cooled motor, s unit / G.V. Vilin, V.A. Denisov, J.G. Polybojarinov, L.I. Shoob. Was pubished in Interuniversiti 1982. Digest N 11.
- Denisov V.A. Using integral pumps in cooling fluid-filled enclosed motor, s units systems / V.A. Denisov, J.G. Polybojarinov. Interuniversiti Digest: NWPI, N 37, Saint Petersburg, 2007.
Similar articles
Modeling and control of dynamical properties of the technological systems
2014 V. V. Maksarov, P. V. Leonidov
Modeling simulation of structure in a heat-affected zone of welded joint from low-alloyed steels
2014 E. I. Pryakhin, D. M. Sharapova