Submit an Article
Become a reviewer
Vol 241
Pages:
105-112
Download volume:
RUS ENG

Methodology for determining the parameters of drilling mode for directional straight sections of well using screw downhole motors

Authors:
Vladimir S. Litvinenko1
M. V. Dvoinikov2
About authors
Date submitted:
2019-10-30
Date accepted:
2019-11-23
Date published:
2020-02-25

Abstract

Article presents results of study on possibility of increasing the efficiency of drilling directional straight sections of wells using screw downhole motors (SDM) with a combined method of drilling with rotation of drilling string (DS). Goal is to ensure steady-state operation of SDM with simultaneous rotation of DS by reducing the amplitude of oscillations with adjusting the parameters of drilling mode on the basis of mathematical modeling for SDM – DS system. Results of experimental study on determination of extrema distribution of lateral and axial oscillations of SDM frame depending on geometrical parameters of gerotor mechanism and modes ensuring stable operation are presented. Approaches to development of a mathematical model and methodology are conceptually outlined that allow determining the range of self-oscillations for SDM – DS system and boundaries of rotational and translational wave perturbations for a heterogeneous rod with an installed SDM at drilling directional straight sections of well. This mathematical model of SDM – DS system's dynamics makes it possible to predict optimal parameters of directional drilling mode that ensure stable operation of borehole assembly.

10.31897/pmi.2020.1.105
Go to volume 241

Similar articles

Cascade frequency converters control features
2020 A. G. Vorontsov, V. V. Glushakov, M. V. Pronin, Yu. A. Sychev
Priority parameters of physical processes in a rock mass when determining the safety of radioactive waste disposal
2020 V. S. Gupalo
Methodology for Calculating the Stability of the Polymer Operating String in Permafrost
2020 V. A. Stetukha, I. I. Zheleznyak
Method for estimating the spectrum density of the resistance moment on the working body of a peat milling unit
2020 K. V. Fomin
Specifying the technical state limit value of the pump pulp without disassembling
2020 N. P. Ovchinnikov, V. V. Portnyagina, B. I. Dambuev
Assessment of operational reliability of quarry excavator-dump truck complexes
2020 V. M. Kurganov, M. V. Gryaznov, S. V. Kolobanov