Equations of transition curves of wheel teeth cut by a rack-and-pinion producing contour with combined profile displacement
Authors:
Abstract
The use of gear pairs with combined displacement of tooth profiles opens up new geometric, kinematic and strength possibilities in the design of gears.
Область исследования:
(Archived) Without section
Funding:
None
References
- GOST 16532-70. Gear spur involute external meshing. Calculation of geometry. M., PH Standards, 1971.
- Ivanov I.P. Gear transmissions with combined displacement of tooth profiles. - Deposited manuscripts / VINITI, 1981, № 11.
- Ivanov I.P. Combined displacement of the producing contour as a reserve of durability of gear transmissions of mining machines. – Journal of Mining Institute, 1981, vol. 89.
Similar articles
Use of differential pressure tubes in compressed air flow measurement at mining enterprises
1983 O. V. Kabanov, V. V. Klassen
Rational rate of hundredth air consumption in pneumatic percussion machines
1983 R. N. Tunkel, I. A. Shelepanov