Selection of some machine parameters for drilling directional wells of long length
Abstract
Modern cone drilling machines for drilling wells from the surface are capable of drilling vertical or inclined wells up to 320 mm in diameter and up to 30 m deep. In the underground development of deposits are used wells drilled at any angle to the horizon, and machines for their drilling provide penetration of wells with a diameter of up to 105 mm and a length of no more than 100 m.
Область исследования:
(Archived) Without section
Funding:
None
References
- Balitsky V.P. - Drilling and Drilling Equipment. M., Nedra, 1964.
- Grigoryan A.M. Stripping of strata by multihole and horizontal wells. M., Nedra, 1969.
- Kalinin A.T. Well Curvature. M., Nedra, 1974.
- Elnyashevskiy I.V., Orsulyak Y.M., Storonsky M.N. Typical tasks and calculations in drilling. M., Nedra, 1974.
- Epstein E.F. Calculation of drill pipes in geologic-exploration drilling. M., Nedra, 1979.
- Fedorov V.S. Design of drilling modes. M., Nedra, 1966.
- Fomenko F.N. Drilling of Wells by Electric Drill. M., Nedra, 1974.
Similar articles
Conducting drilling and blasting works in cramped conditions
1984 V. P. Tarasenko, V. I. Sivenkov, V. V. Pupkov
Теоретическая оценка влияния скольжения зубьев на эффективность бурения горных пород шарошечными долотами
1984 G. M. Kryukov, Ny Van Bak
Asymptotic small heat conduction solution of the Stefan problem of permafrost thawing in an electromagnetic field
1984 L. E. Rickenglaz