Influence of cutting speed of a combine harvester on its technical productivity
Authors:
Abstract
When a combine harvester operates at a rational cutting speed, maximum productivity is ensured at given values of resource and safety indicators. These conditions will be met if the optimum thickness of the "chip" is provided, which determines the ratio of the dynamic component of the load and friction power.
Область исследования:
(Archived) Without section
References
- Berman V.M., Vereskunov V.N., Rylov G.S. Investigation of load formation in drives of cutting systems of mining machines depending on their characteristics. - Scientific Works of A.A.Skochinsky Institute of Mining Engineering, 1979, issue 172.
- Kolomiytsov M.D. Method of Forecasting of Combine Harvester Run. - Zap. LGI, 1981, vol. 87.
- Kolomiitsov M.D., Nguyen-Pham-Thuc. Numerical Indicators of Combine Harvester Quality. - Coal Engineering. Scientific and Technical Abstract Collection of the Central Bureau of Scientific and Technical Information of the Ministry of Coal Industry of the Ukrainian SSR, 1979, No. 8 (32).
- Modeling of coal destruction by cutting tools / Edited by Y.D. Krasnikov. M., Nauka, 1981.
- OST 12.44.258-84. Cleaning combines. Parameter selection and calculation of friction and feed forces on the executive bodies. M., izd. Minugleproma USSR, 1984.
- Pozin E.Z., Malamed V.Z., Ton V.V.. Destruction of coals by mining machines. M., Nedra, 1984.
Similar articles
Analysis of dynamic properties of the drive of the executive body of the combine harvester of the GPC combine
1986 B. S. Makhovikov
Analysis of conformity of the equipment of non-metalliferous industry with modern requirements of labor protection
1986 Yu. N. Marusov, Yu. S. Fedorov