Bending stresses of gear teeth with combined profile displacement
Authors:
Abstract
Gears with combined (radial and tangential) offsets of involute tooth profiles have great possibilities to meet the strength and geometric-kinematic requirements of.
Область исследования:
(Archived) Without section
References
- GOST 21354-75. Cylindrical involute spur gears. Calculation of strength. M., PH of standards, 1982.
- Ivanov I.P. Comparative estimation of strength of gear teeth with combined displacement, M., NIImash, 1983.
- Ivanov I.P. Gears with combined displacement of tooth profiles. Moscow, NIImash Publishing House, 1981.
- Ivanov I.P. Equations of transition curves of wheel teeth cut by a rack and pinion producing contour with combined mixing of profiles. – Journal of Mining Institute, 1983, vol. 97.
- Levanov V.L. Connection of limit loads with local stress form coefficients. -In the book: Toothed and worm gears / Under edition of N.I.Kolchin. L., Mashinostroenie, 1968.
- Determination of Stresses in Dangerous Sections of Complex Shaped Parts. Method of non-planar sections (A.V.Verkhovsky, V.P.Andropov, O.K.Lupanova, V.I.Chevkinov. M., Mashgia, 1958.
Similar articles
Errors of experimental determination of efficiency of gear mechanisms on stands with closed power flow
1986 G. A. Terekhov
Analysis of conformity of the equipment of non-metalliferous industry with modern requirements of labor protection
1986 Yu. N. Marusov, Yu. S. Fedorov