Features of calculation of thermal modes of traction belts of intermediate vacuum drives with sliding supports
Authors:
Abstract
The efficiency of operation of conveyor transport can be significantly increased by using multi-drive belt conveyors (MDBC), which allow to use the full width of belts, use belts of reduced strength, as well as significantly reduce the cost of mining and capital works by eliminating transfer points.
Область исследования:
(Archived) Without section
Funding:
None
References
- Derr E., Valechek E. Long length belt conveyor installations at mines of the company "Bergbau AG Lippe" - Gluckauf, 1985, No. 21.
- Krasnoshchekov E.A., Sukomel A.S. Zadachnik on heat engineering. - M., Energia, 1975.
- Pipko A.I., Plisovskiy V.Ya., Penchko E.A. Design and calculation of vacuum systems. M., Energia, 1979.
- Platonov V.F. Bearings from polyamides. М. Mashgiz, 1963.
- Jungmeister D.A. Laboratory studies of intermediate vacuum drive of belt conveyor. - In the book: Rational means and systems of potash mines mechanization. L., PH VNING, 1984.
Similar articles
Determination of operation level and condition of tailing ponds by the method of expert evaluations
1987 G. A. Railyan
Peculiarities of hydraulic transportation along inclined slurry lines with siltation layer
1987 A. S. Medvedev
Qualitative and quantitative characteristics of hydromixtures of copper ore dressing tailings of Dzhezkazgan MMC
1987 I. Sh. Dzhunusov
Determination of the final velocity of serpentinite ore grains from the Punta Gorda deposit falling in water
1987 M. Suarez, V. Labrador