Submit an Article
Become a reviewer
Vol 138
Pages:
102-107
Download volume:
RUS
Research article
Without section

Method of calculation of vector dimension chains

Authors:
A. P. Batalov
Date submitted:
1992-09-08
Date accepted:
1992-11-19
Date published:
1993-12-28

Abstract

Errors in the manufacture of parts and assembly of units: deviations from the alignment of cylindrical and conical surfaces, deviations from the perpendicularity of the ends, arbitrary, random distribution of the gap in the interface and the associated displacement of the part and other similar, are characterized not only by the magnitude but also by the direction.

Go to volume 138

References

  1. Бронштейн И.Н., Семендяев К.А. Справочник по математике. М.: Наука, 1986. 720 с.
  2. Дунин-Барковский И.В. Взаимозаменяемость, стандартизация и технические измерения. М.: Машиностроение, 1976. 551 с.
  3. Методические указания. Цепи размерные. Основные понятия, методы расчета. РД-50-426-83 / ВНИИНМаш. М., 1986. 45 с.
  4. Уразаев З.Ф. Теоретико-вероятностное суммирование допусков на векторные погрешности // Взаимозаменяемость и технические измерения в машиностроении / Peд. К.И. Абаджи и Б.П. Тимофеев. Л.: Машиностроение, 1972. С. 28-32.
  5. Шевелев А.С. Теоретико-вероятностный метод расчета векторных размерных цепей // Взаимозаменяемость и технические измерения в машиностроении / Ред. К.И. Абаджи и Б.П. Тимофеев. Л.: Машиностроение, 1972. Вып. 6. С. 12-22.

Similar articles

Maximum stresses in tooth contact of spur gears
1993 I. P. Ivanov
Methods of determining the service life of mining equipment
1993 M. D. Kolomiytsov, B. S. Makhovikov
Determining the optimal match between the average and instantaneous loads of mining machines
1993 A. M. Meshkov
To the issue of studying the loading of resilient systems of dump trucks in the process of movement
1993 N. V. Zyryanov, V. Yu. Koptev
Determination of bulk cargo motion parameters on curved surfaces with constant radius of curvature
1993 Yu. D. Tarasov
Automated calculation of optimal cutting modes during machining
1993 Yu. P. Boytsov