Submit an Article
Become a reviewer
Vol 155 No 2
Pages:
68-70
Download volume:
RUS

Determination of rational parameters of drainage excavations in the emission hazardous zones of potassium formations

Authors:
E. R. Kovalskii
About authors
  • G.V. Plekhanov Saint Petersburg Mining University
Date submitted:
2002-07-28
Date accepted:
2002-08-03
Date published:
2003-02-01

Abstract

Taking into account the theory of formation of blowout-hazardous zones of dip trough type, the average statistical parameters of cavities of artificially initiated salt and gas emissions were determined for the conditions of the Starobinskoye field. Dependencies for determining the location of the center of the blowout zone in the vertical and horizontal planes are derived. The way of transition of emission-hazardous zones during excavation of the Third Potash Seam at full capacity is concretized. The correlation between the slope angle of the advanced drift with the initiation cut, which serves for artificial decoupling of the release, and the geometric parameters of the release zone was found. When conducting the advance face with the initiating jaw in the direction to the center of the trough core during the initiation of the outburst, taking into account this dependence will reduce its intensity, increase the safety of mining operations, as well as improve the economic indicators of the method of transition of the outburst-risk zone by the longwall.

Go to volume 155

References

  1. Сиренко Ю.Г. Разработка способов пересечения выбросоопасных зон при выемке Третьего калийного пласта Старобинского месторождения на полную мощность / Ю.Г.Сиренко, В,Р.Ковальский // Записки Горного института. 2002. Т.152 (1). С.85-88.

Similar articles

Analysis of the results of application of enhanced oil recovery technologies and the choice of bottomhole zone treatment method for reservoir D1 of the Miadsey field based on well 47
2003 A. G. Ruzhnikov
Environmentally friendly technologies for disintegrating clay sands in the development of gold and platinum deposits
2003 A. V. Karepanov
Improving the quality of wellbore cementing by applying the technology of vibrating the entire length of the production string during the initial period of waiting for cement curing
2003 L. I. Garipova, R. A. Usmanov
Experimental determination of the contact thermal resistance of steel pipes with rolled and L-shaped wound aluminum alloy fins
2003 K. B. Semenido
Theoretical justification of the effective type of turbo-motor for the drive of hydraulic motors
2003 A. L. Bukin
Theoretical analysis of water supply means of high-pressure self-propelled hydromonitors
2003 V. Yu. Mizurev