Submit an Article
Become a reviewer
Vol 157
Pages:
167-170
Download volume:
RUS

Experimental evaluation of wear resistance of spur gears

Authors:
S. L. Ivanov1
A. S. Fokin2
About authors
  • 1 — G.V. Plekhanov Saint Petersburg State Mining Institute
  • 2 — G.V. Plekhanov Saint Petersburg State Mining Institute
Date submitted:
2003-07-19
Date accepted:
2003-08-21
Date published:
2004-09-17

Abstract

Extensive opportunities to influence the properties of involute gears are available with combined displacement of tooth profiles - a combination of radial and tangential displacements, including the use of cutting tools with a standard initial contour. In particular, by combined displacement, the bending strength and wear resistance of cylindrical gear teeth can be increased by one and a half to two times, which is commensurate with material replacement.

Go to volume 157

Similar articles

Development, research and implementation of environmental equipment
2004 E. V. Parakhonskii
Determination of feed force on drilling tools depending on the direction of the wells
2004 K. P. Khmyznikov
Bulk inline crushing of rock mass by mobile machines with powerful percussion units as an alternative to drilling and blasting
2004 Yu. D. Krasnikov
Prospective directions in the field of transport machine reliability analysis
2004 Yu. A. Plyutov, S. V. Doronin
Experimental studies of the thickening process of slurry in the near-bottom zone
2004 Yu. D. Tarasov, P. V. Shishkin
Bench tests of pneumatic perforators with a twin hammer
2004 V. A. Pivnev, Z. A. Sazhko, Yu. V. Sudenkov, D. A. Yungmeister, A. L. Kuripko