Comparative analysis of mill calculation methods and selection of their optimal ratio
Authors:
About authors
- Student G.V. Plekhanov Saint Petersburg State Mining Institute
Abstract
At modern concentrating factories of 70 % of expenses of the electric power it is necessary on preparation of ore, and 2/3 these expenses fall on milling. Mills should provide demanded granulation of grinding at peak efficiency of crushing and minimally possible capacity on a drive. Therefore important correctly to choose a method for calculation of mills.
Область исследования:
Metallurgy
Funding:
None
Similar articles
Estimation of selectivity of protection devices against single phase earth faults in 6(10)kV mine networks
2009 P. A. Rogov
Numerical modeling on the basis of the method of finite differences of some applied problems of geomechanics
2009 A. P. Gospodarikov, M. A. Zatsepin, A. V. Meleshko
Economic estimation of formation and use of reserve fund of oil products on the territory of North-West Russia
2009 E. I. Sapozhnikova