Comparative assessment of wear intensity of large-modular gears depending on lubrication conditions
About authors
- 1 — Professor G.V. Plekhanov Saint Petersburg State Mining Institute
- 2 — Postgraduate student G.V. Plekhanov Saint Petersburg State Mining Institute
- 3 — Postgraduate student G.V. Plekhanov Saint Petersburg State Mining Institute
Abstract
Ways to raise service life of open tooth gearings on an example of a drive of a spherical mill are considered. Results of introduction of automatic system of greasing are resulted and increase ways efficiency of its uses are offered.
Область исследования:
(Archived) Geotechnical engineering, powerengineering and automation
Similar articles
Mathematical and simulation models of the inertial resonant jaw crusher with the electric drive of the reciprocating-rotating motion
2009 Yu. A. Gavrilov
Comparative analysis of mill calculation methods and selection of their optimal ratio
2009 A. V. Alikin
Experimental studies of the parallel active filter operation modes in the networks of Orenburgneft
2009 Yu. A. Sychev