Comparative assessment of wear intensity of large-modular gears depending on lubrication conditions
About authors
- 1 — Professor G.V. Plekhanov Saint Petersburg State Mining Institute
- 2 — Postgraduate student G.V. Plekhanov Saint Petersburg State Mining Institute
- 3 — Postgraduate student G.V. Plekhanov Saint Petersburg State Mining Institute
Abstract
Ways to raise service life of open tooth gearings on an example of a drive of a spherical mill are considered. Results of introduction of automatic system of greasing are resulted and increase ways efficiency of its uses are offered.
Область исследования:
(Archived) Geotechnical engineering, powerengineering and automation
Funding:
None
Similar articles
Application of fuzzy logic theories at compensation of higher harmonics by active filter
2009 A. P. Shevchuk
Investigation of operation and control of electromagnetic valves of the system of mobile reference complex for oil well productivity estimation
2009 A. N. Lyubchik
Use of dynamic interpretation of seismic data to predict reservoir properties in carbonate section
2009 A. V. Ekimenko
Assessment of prospects of development of the internal market of coal in modern conditions
2009 A. N. Martemyanova