Application of plasma aluminide coatings for increasing the reliability of operation of gas turbine engine blades
Authors:
About authors
- Student G.V. Plekhanov Saint Petersburg State Mining Institute
Abstract
There is shown possibility of using covering consists of Сr-Co-Al-Y for protection blades of turbines that are used in compressor stations. In conclusion it is said that using these coverings increase reliability of exploitation of turbine’s blades and give opportunity for developing jet turbine engines for rising of efficiency.
References
- Болобов В.И. Высокотемпературное окисление некоторых металлических материалов в присутствии атомарного кислорода / В.И.Болобов, К.М.Макаров // Защита металлов. 1992. № 6.
- Зубченко А.С. Марочник сталей и сплавов. М.: Машиностроение, 2003.
- Зязев В.Л. Жаростойкость плазменных алюминидных покрытий системы Cr-Co-Y-Al в условиях циклического нагрева на воздухе / В.Л.Зязев, В.А.Ватолин, Р.И.Гуляева и др. // Металлы. 2003. № 1.
Similar articles
Investigation of engineering and geological features of Lower Cretaceous and Paleo-Gene Sediments as a base for cement plant structures (Republic of Mordovia)
2009 K. V. Pankratova
Slaughtering electrode heat and steam generator for thermal methods of extraction of high-viscosity oil
2009 E. E. Melnikova
Prediction of filtration-capacity properties of the reservoir in the Lower Permian sediments of the Timan-Pechora province based on seismic and GIS data
2009 A. A. Vazaeva